ClearMirror Shower ClearMirror Series Handleiding voor installatie-instructies - Pagina 4
Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} ClearMirror Shower ClearMirror Series. ClearMirror Shower ClearMirror Series 6 pagina's. Fog-free shower mirrors
Pagina afdrukkenNOTICE: This stage requires two people. One to hold the mirror and another to connect the
wires with UL approved wire nuts or snap connectors.
DO NOT LET MIRROR HANG FROM CONNECTED WIRES!
MOUNTING THE MIRROR
1. Install tile to the edge of your marked mirror location. Account for the grout line width to match
your tile design.
2. Connect power supply wire leads to the wire leads on the mirror heater with UL-approved wire
connectors. Wrap with electrical tape.
3. Position the connectors and wire leads in the low-voltage junction box.
4. Test to make sure the heater is working. It takes 3 to 5 minutes to heat the mirror.
5. Apply mirror mastic adhesive to the mirror back. It is safe to apply mastic on the heater.
6. Apply a continuous bead around the entire edge perimeter to protect mirror (see Figure 2).
7. Connect the leads from the heater to the power supply leads (polarity is non-relevant).
8. Place mirror into opening keeping a consistent boarder around the mirror to match existing
grout lines.
9. Securely tape and brace the mirror in place for 24 to 48 hours or until dry.
Low-voltage
Plug-in
Transformer
18 Gauge
Supply Leads
Switched 120V
Outlet Supply
Use Premium Mirror Mastic for Best Results
To prevent damage to the mirror backing, use Gunther Premier Plus Mirror Mastic. It is available
from your local mirror/glass specialist or online through Amazon or CR Laurence.
This product does have a shelf life so we are not able to provide it with your shower mirror.
Other mirror mastics will work but Gunther Premier Plus is recommended. See clearmirror.com/FAQ
Wall Board
Low -voltage
Junction
Box
Figure 2. Connecting the wires and applying mirror mastic.
¼" Mirror:
Front Side
Apply continuous mastic
bead around the entire
edge of mirror back to
Heater
create a moisture seal.
Mirror Back
Heater