ESi Ergo VICTORY 2VT-C36-24 Series Gebruiksaanwijzing - Pagina 4

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} ESi Ergo VICTORY 2VT-C36-24 Series. ESi Ergo VICTORY 2VT-C36-24 Series 8 pagina's. 2 leg electric table base

Pagina afdrukken

VICTORY 2 LEG ELECTRIC TABLE BASE

STEP 6

Adjust the position of the frame before screwing it

to the table.

• The top supports on each side should be

approximately 1" (25mm) from the ends of the

table.

• The rear of the feet should align with the rear

of the table.

STEP 7

Once in their final position, attach the top supports

and cross channels to the table.

• Use ST4.8x19 screws (8 total required).

• Attach the screws through the mounting tabs on

the cross channels and through the holes at the

ends of the two top supports.

STEP8

Tighten the M10 set screws in the cross channels

(8 total). Use the 5mm Allen key to hand tighten.

STEP 9

Attach the digital keypad using the two ST2.9x19

screws.

• Position the digital keypad on the left or right side

of the table, according to user preference.

• Align the top of the keypad with the edge of the

table so that the controls will be easily accessible.

STEP 10

Attach the control unit using two ST4.8x19 screws.

• Position the control unit near the back of the

table, on the same side as the digital keypad.

• Be sure the cable from the keypad can reach

the control unit, and the motor cables can

extend from the control unit to both motors.

Align Rear of Feet with Rear of Table

ST4.8x19

ST2.9x19

Digital Keypad

Control

Unit

ASSEMBLY

Tighten

Set Screws

Aligned with

Edge of Table

ST4.8x19