ClearOne CLOCKAUDIO TS-001 Technische opmerking - Pagina 5

Blader online of download pdf Technische opmerking voor {categorie_naam} ClearOne CLOCKAUDIO TS-001. ClearOne CLOCKAUDIO TS-001 6 pagina's. Using the clockaudio ts-001 with the converge pro

Pagina afdrukken

Clock Audio Connections

SWITCH WIRE COLOR

FUNCTION

When the touch switch on the ClockAudio TS-001 is pressed, a contact closure is sent to the Converge Pro Control Pin. The Converge Pro mutes

the microphone channel and sends out a "Mute On" response. With the "Mute On" response, the first status pin is pulled to ground and the second

status pin releases. Thus the green LED's turn on and the red LED's turn off.

When the touch switch is pressed again on the ClockAudio TS-001, a contact closure is sent to the Converge Pro Control Pin. The Converge Pro

toggles the mute state of the microphone channel, un-muting the channel, sending out a "Mute Off" response. With the "Mute Off" response, the

first status pin releases and the second status pin is pulled to ground. Thus the green LED's turn off and the red LED's turn on.

CONVERGE PRO 840T CONTROL/STATUS PROGRAMMING

The Converge Pro Control Status Port A must be programmed to control the muting of the microphone input and illuminate the LED's in the halo.

This programming may be done while connected to the unit or while offline and saved to your site file for future use.

To program Control Status Port A follow the steps below, referencing Image 4:

In the Converge Console, go to the Control Tab section and select Control Port A and Selected Pin 1 from the respective drop-down lists.

Click on the Active (Low) Command button.

Brown

+ 12 VDC

Yellow

Open Collector Switch (Logic LOW when switch pressed)

Blue

Ground

Green

Grounded provides Green LED illumination

Red

Grounded provides Red LED illumination

FUNCTION

Image 4