CamOne Xplore Handmatig - Pagina 4

Blader online of download pdf Handmatig voor {categorie_naam} CamOne Xplore. CamOne Xplore 13 pagina's. Full hd videocamera

Preparation

Compensation for recorded content

ACME will not be responsible in any case for any consequential or direct problems that will

lead to a loss of recorded or edited data. Furthermore ACME will not guarantee the content in

case the recording or saving is not working properly. The above limitations are as well valid in

case the unit has been repaired.

Do not remove the micro SD Card while recording or saving. Do not switch off or take out the

battery before the recording has been stopped or as long there is access to the memory,

indicated by a rotating circle.

Protect the unit from extreme temperatures. Stop recording at temperatures less than minus

10°C and higher than 60°C. Remove the camera from the windshield/sucking pad in case

extreme temperatures might be possible!

It is known that forged accumulators which remarkably look like the original product are

offered for the sale again and again. Some of these accumulators are not equipped with a

proper protection circuit which would satisfy the regulations of the prevailing safety

regulations. These accumulators can perhaps lead to fires or explosions. We assume no

liability for accidents, damages or failures which result from the use of a forged accumulator.

Please note that the camera is splashproof. A strong and durable suspension of

moisture harms the camera!

!!!The cam is not waterproof!!!

Insert/ Replace battery

Twist off the end cap of the camera. Below you will find the battery case and further

interfaces.

Insert the battery by following the contacts of the camera.

Only use the original replacement battery (Art-Nr.: COXP08).

Batteries of other suppliers may have different polarities and cause damages.

You can alternately use the 5V USB-Power adaptor (Art. No.: FCHD43).

The inside battery is not fully charged when being

purchased. Please charge the battery before using

the CamOne Xplore for the first time.

Connect the camera with your computer using the

included USB-cable. The charging process is

indicated by the red LED light which switches to

green as soon as charging is finished.

Charging takes around 2 hours.