Altox Timer-2 Bedieningshandleiding

Blader online of download pdf Bedieningshandleiding voor {categorie_naam} Altox Timer-2. Altox Timer-2 4 pagina's.

Technical speciﬁcation

Rated supply voltage of the device

Current consumed in standby mode

Maximum current of the control output LINE

Maximum analogue output current OUT

Connection diagram

— Connect the power wires through the 500 mA fuse to the battery

terminals or to the OBD-II connector wires (16pin is +12V, 4pin is common).

— The INPUT is connected to an external control source. Waits for a pulsed

GND signal of at least 200 ms duration or a signal with a constant level of

GND (ﬁxation after 10 seconds).

— The OUT output commutes GND. The output is designed to control the

climate control unit in P0 mode or the coolant circulation pump in modes

P1 and P2 using a power relay.

RED

+12V / 24V (via the fuse 500mA)

BLACK

GND (common)

GREEN

INPUT

YELLOW

LINE (digital and analogue signal)

WHITE

OUT

— LINE is connected to the parking heater control input (digital or analog,

the type of heater is changed through the settings of the mini-timer)

Attention!

By default, the device is conﬁgured to automatically detect the digital

type of the heater - setting "A0". To control the heater with an analogue

signal, it is necessary to manually set this type of heater - "A1" in the

device settings.

Note: The device is ﬁxed at the installation site using double-sided tape or

other fasteners.

Authorized service:

Installation date:

—

10V–28V

—

4-5mA

—

50mA

—

150mA

Altox

O p e r a t i o n a l M a n u a l

ALTOX TIMER-2