ClearSpan SunBurst Gebruiksaanwijzing - Pagina 6

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} ClearSpan SunBurst. ClearSpan SunBurst 13 pagina's. Dome tents

Pagina afdrukken

CLEARSPAN

DOME TENTS

™

FRAME ASSEMBLY

Gather the parts:

•

Pipes 1.315" x 63" swaged (#131S063D)

•

Pipes 1.315" x 21" plain (#131P021D)

•

Pipes 1.315" x 51" plain (#131P051D)

•

Pipes 1.315" x 90" plain (#131P090D)

•

3-way corner couplers (#103933)

•

4-way crown coupler (#103930)

•

Carriage bolts (FAH005B) and nuts (FALB01B)

•

Tek screws (FA4484B)

1. Using the Front Profile diagram in the Quick Start

section, assemble the four (4) hip rafter pipes.

Each hip rafter is assembled using one (1) 21" plain

pipe (#131P021D) and one (1) 63" swaged pipe

(#131S063D).

NOTE: Slide the swaged end of the pipe into the plain,

non-drilled end of the shorter pipe. Position the drilled

ends of all pipes at the end of each pipe assembly. The

holes are used to secure the pipe assemblies to the

couplers and crown fittings.

2. Take each hip rafter pipe assembly and attach it to the

crown fitting. Tighten the mounting bolts.

Crown

Fitting

NOTE: Use the 1/4" x 2" carriage bolts and nuts to

secure each assembly to the crown fitting.

Visit www.ClearSpan.com for additional products and customer assistance.

3. Using the Front Profile diagram in the Quick Start

section, assemble the four (4) base rafter pipes.

Each base rafter is assembled using one (1) 51"

plain pipe (#131P051D) and one (1) 63" swaged pipe

(#131S063D).

4. Take the corner couplers and the assembled base

rafter pipes and construct the roof frame of the tent.

NOTE: Secure the completed pipe assemblies to the

corner couplers using the 1/4" bolts and nuts.

Some couplers may have more than one mounting hole for the

different rafter pipes. Use the mounting hole that is positioned

closest to where the rafter pipe is inserted into the coupler.

5. Return to each rafter pipe splice and verify that all

pipes are seated at the joints.

6. Using the supplied Tek screws (FA4482B) and the

nut setter (100441), secure each rafter pipe splice as

shown above.

Corner

Coupler

NOTE: Install all Tek

screws in a location

that will not touch

the main cover

when it is installed.

To protect the cover,

wrap duct tape

(customer-supplied)

around the Tek

screws and pipe

splice if desired.