ClearView PowerBoards PB -TA-004 Handleiding voor installatie-instructies - Pagina 9

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} ClearView PowerBoards PB -TA-004. ClearView PowerBoards PB -TA-004 16 pagina's. Toyota land cruiser 79 series 1984 - current

Pagina afdrukken

Fitting Instructions

The following instruction is for installation of the right-hand side Power Board.

Follow same instructions for installation of left-hand side Power Board.

IMPORTANT

Clearview recommends this installation to be completed by a professional. Incorrect

installation may cause damage to your vehicle and possible personal injuries.

Step 3

Installing mounting brackets to vehicle

3.1 Locate and remove the factory rubber grommets

underneath the vehicle sill rail.

Feed the supplied M8 T Bolts through the opening found on

vehicle sill rail, so that the T section is on the inside of the rail

and thread is exposed on the outside of the rail.

The opening is located approximately in line with the front

door centre line.

Use the supplied plastic retainer together with the T Bolt to

keep bolt in place.

3.2 Disassemble the mounting bracket assembly by undoing the M8 nuts as shown below.

Avoid mix-up of components.

This will separate the Top Mounting Bracket from the Swivel/Idler Brackets.

clearviewaccessories.com.au