ClearView RT-RT108 Handleiding voor installatie-instructies - Pagina 12

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} ClearView RT-RT108. ClearView RT-RT108 20 pagina's.

Assembly Instructions

IMPORTANT: This next step is critical in

ensuring that the MUDFLAP SYSTEM is

properly installed. All measurements

should be made while tow vehicle has

full tongue weight. (Mudflap to be a

minimum of 100mm off the ground)

8. Make sure SUPPORT RODS are level on both sides and measure the distance from the

bottom of FLAP SUPPORT ROD to the ground. Subtract the desired ground clearance

(3"- 4" recommended or 75 mm – 100 mm).

Refer Image 7.

9. Lay MUDFLAP down with grooved side up on flat surface. Measure desired MUDFLAP

length from the bottom up. Find the nearest pre-molded CUT LINE GROOVE and mark.

Refer Image 8.

IMPORTANT:

Before cutting and

drilling/punching holes, make

sure to place either a scrap piece

of wood or thick cardboard

underneath MUDFLAP to avoid

any surface damage.

Measure with

each side

Ground

Clearance

(3" - 4")

clearviewaccessories.com.au

Measure

Mudflap

length

Ground

Measure

Mudflap

length

100mm

IMAGE 7

Ground

Clearance

(3" - 4")

IMAGE 8

Cut Guide Grooves