ClearView RT-RT110 Handleiding voor installatie-instructies - Pagina 16

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} ClearView RT-RT110. ClearView RT-RT110 20 pagina's.

Assembly Instructions

19. Finalise width adjustment of FLAP SUPPORT RODS by sliding them in or out of the

HUB ARMS. Refer Image 5.

Note: It is recommended that the final MUDFLAP position extends a minimum

of 2" from outer edge of tyre.

IMPORTANT: Evenly tighten the three M6 ARM CLAMP BOLTS beginning with

the center bolt and moving from one to another on each side until all are tight.

The SLOT will NOT close. (70-80 in-lbs torque [5mm ALLEN WRENCH])

Flap Clamp

Bolts (5)

Trim Plate

Bolts (8)

20. Tighten the five M8 FLAP CLAMP BOLTS on each of the FLAP CLAMPS.

Refer Image 10. (30 in-lbs torque [13mm socket or wrench])

IMPORTANT: SUPPOR T RODS MUST NOT BE ABLE TO ROTATE or MOVE IN HUB

ARMS or FLAP CLAMPS.

Arm Clamp for fine

width adjustment

See Detail D

clearviewaccessories.com.au

Flap Support Rods

Rod End Caps with

Nut and Bolts

Flap position holes

must face forward

Square Hole

Detail D

Same as IMAGE 5

Same as IMAGE 10