ClearWater FS016 Gebruikershandleiding - Pagina 4

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} ClearWater FS016. ClearWater FS016 4 pagina's. High rate sand filter, standard system with one-piece base

Pagina afdrukken
MOTOR DOES NOT START:
THERMAL OVERLOAD TRIPS:
NO WATER FLOW:
READ AND FOLLOW ALL INSTRUCTIONS! SAVE THESE INSTRUCTIONS!
WARNING! To reduce the risk of injury and product damage:
Feeders are designed to use only Chlorine (Trichloro-s-triazinetrione) or Bromine
(Bromochloro -5, 5 Dimethylhydantoin) tablets, slow dissolving type. UNDER NO
CIRCUMSTANCES MIX Trichlor OR Bromine with Calcium Hypochlorite, with other forms of
concentrated chlorine, or with other chemicals FIRE AND/OR EXPLOSION MAY RESULT.
NEVER use oils or grease to lubricate 0-ring. Oil in contact with Trichlor OR Bromine may result
in FIRE. Caution should be used when removing feeder cap. Do not inhale fumes.
If shock treatments or Algaecides containing chemicals other than sanitizer tablets in feeder
must be used, then turn off feeder OR remove tablets until the shock or algae treatment is
complete and all granules have dissolved. Failure to do so may result
Designed,
Engineered &
Manufactured
in the USA.
©2018 Waterway Plastics
Make sure motor is plugged in.
Circuit breaker in OFF position.
Thermal Overload in tripped position.
Wiring installation incorrect.
Incorrect line voltage.
Defective wiring.
Low voltage.
Wiring installation incorrect.
Dual voltage pumps mis-wired.
Inadequate ventilation.
Obstruction of suction or return line.
Clogged impeller.
Suction system air leaks.
Slice valve closed.
Clogged hose fitting.
Clogged basket.
Dirty sand.
CHLORINATOR & BROMINATOR USE WARNINGS
For product registration visit: www.waterwayplastics.com.
For Warranty questions or claims please contact point of purchase.
2200 East Sturgis Road, Oxnard CA 93030 • Phone 805.981.0262 • Fax 805.981.9403
www.waterwayplastics.com • [email protected]
TROUBLESHOOTING
EXCESSIVE PUMP NOISE:
INADEQUATE FILTERING:
in granules mixing in feeder causing FIRE AND/OR EXPLOSION. The shock or algae treatment
dissolved in water is safe with tablets.
ALWAYS WEAR PROTECTION for eyes, skin and clothing when working with chemicals. Do
not smoke and avoid sparks and open flames. Turn off pump and control valve before opening
chlorinator. Use of bulk chemicals may result in damage to pool.
Chemicals will dissolve very quickly and may cause bleaching to liner due to over-chlorinating,
possibly causing unsafe pool conditions.
Settings in excess of the recommended control setting levels for the chlorinator can result in
excess chlorine being discharged in your pool. This can result in bleaching or discoloration of
areas around the pool inlet or in some cases bleaching of the entire pool liner or paint (CHECK
CHEMICAL RESIDUALS REGULARLY).
WARRANTY
Worn bearings.
Suction line clogged.
Pump incorrectly mounted.
Hose fitting partially closed.
Slice valve partially closed.
Clogged trap basket.
Sand level too low.
Inadequately cleaned system.
Excessive dirt load.
Chemical imbalance.
Inadequate system pressure.
SAND FILL CHART:
Model FS016 - 50 lbs.
Model FS019 - 100 lbs.
Model FS022 - 150 lbs.
Model FS026 - 200 lbs.
810-0082-1.0618