Altrason Humidry BIF Series Gebruikershandleiding - Pagina 10

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Altrason Humidry BIF Series. Altrason Humidry BIF Series 13 pagina's. Ceiling mounted desiccant rotor multifunctional dehumidifier

Pagina afdrukken

Clean Filter Reminder:

・

The unit will remind you when it is time to clean the filter.

Please clean the filter as soon as possible when the

reminder appears.

・

Use clean water to rinse the filter or a vacuum to clean the

filter. In the event of major stain, please use neutral cleaner

for cleaning and place back into the unit after drying. The

words "TOP" should face up when replacing the filter as it

has directionality.

※

Read carefully the safety precautions on page 2

about cleaning the ﬁlter.

Please stop unit operations and contact qualified technicians when the issue cannot be fixed as

described in this section. Switching off the circuit breaker to ensure power is completely cut off.

Problem

Unit failed

to start

Vibration or

abnormal

noise

Unable to

control with

Wall Panel

Unable to

control with

Remote Control

Cleaning the Filter

Troubleshooting

Possible Cause

Unit not powered

Unit and wall panel not connected

Insufficient ceiling strength

Insecure installation

PTC crackling sound

Controlling the Wall Panel with wet hands

Bad Wall Panel connection due to

loose wire

Remote Control doesn't have enough power

Batteries installed incorrectly

WARNING

Make sure the power is shut off

before cleaning the ﬁlter.

Correction

Please check to make sure the breaker

and power lines are connected, power

cord plugged.

Make sure the LED indicator is displaying

normally and check the connection of the

cable to the Unit and the Wall Panel.

Make sure the unit is securely mounted

on suitable material in the ceiling.

Secure the screws.

PTC heater will activate during Smart

Room Heating, Enhanced Dehumidification,

or Smart Clothes Drying, which may create

a sound due to heating and cooling of air

around the PTC. Not a malfunction.

Please dry your hands.

Unplug the Wall Panel and plug it back in.

Change new batteries.

Make sure the battery direction is correct.