EDIATec ECW100 Bedieningshandleiding - Pagina 9

Blader online of download pdf Bedieningshandleiding voor {categorie_naam} EDIATec ECW100. EDIATec ECW100 15 pagina's. Collision warning unit
Ook voor EDIATec ECW100: Installatiehandleiding (14 pagina's)

Pagina afdrukken
EDIATec ECW100 Bedieningshandleiding

9. Status Display

The green Status Display LEDs operate as follows; normal operating mode is underlined:
 Receive: Lights up when a signal is detected from another aircraft less than 2 km
away, with a height separation of less than 500 m; otherwise the LED is dark. If the
warning is temporarily suppressed (see below) but signals are still received from other
aircraft, then the LED flashes.
 Send: Lights constantly during operation and indicates that the on-board ECW100 is
transmitting. Transmission requires GPS reception.
 GPS: Lights constantly during operation (with very brief interruptions once per sec-
ond). If the LED is constantly dark and flashes briefly once per second, then there is no
GPS reception. When switching on this condition can take several minutes.
 Power: Lights constantly during operation. If the LED flashes, then the power supply
has dropped below 8 V. ECW100 will not operate below 8 V DC.
The 'Receive' and 'Send' LEDs give no indication of ECW100's transceiver range.

10. Push Button

Button "Mode"
The push button "Mode" can be used to select the following functions:
 Push (2 s) changes mode between <Nearest> and <Collision>. Visual confirmation.
Default setting <Nearest>.
 Double Push suppresses optical and acoustic warnings for five minutes. Suppression
is followed by declining note, normal setting followed by a rising note. A double push
terminates the suppressed operation at once.
 Long Push (>8 s): Re-boot. This procedure is recommended if a fault is apparent. No
confirmatory sound signal.
 Very long push (>20 s) brings ECW100 back to the factory settings. The very long
push deletes all configurations that have been loaded by the user. No confirmatory
sound signal.
 Activate the external display update by pushing the button four times in rapid
succession. For details see the Installation Manual.
Button "+"
 Brief Push (<0.8 s) increase the volume. A short sound is emitted at the new volume
selected. The default setting is <loud>.
Button "-"
 Brief Push (<0.8 s) decrease the volume. A short sound is emitted at the new volume
selected. The default setting is <loud>.
Page 9