ARTFOX Lighting IP STROBE 1008 Gebruikershandleiding - Pagina 7

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} ARTFOX Lighting IP STROBE 1008. ARTFOX Lighting IP STROBE 1008 8 pagina's. 1008 white led strobe blinder wash light

Pagina afdrukken

connectors: Pin 1: GND, Pin 2: Negative signal (-), Pin 3: Positive signal (+)

9. Configuring the fixture for DMX control

About DMX

The fixture can be controlled using signals sent by a DMX controller on a

number of channels (which varies depending on the DMX mode that has been

set).

The first channel used to receive data from a DMX control device is known as

the DMX start address. Each fixture must have a DMX start address set. For

example, if a fixture has a DMX address of 10 and it is in 4-channel DMX mode,

then it uses channels 10, 11,12 and 13. The following fixture in the DMX chain

could then be set to a DMX address of 14. If two or more DMX fixtures of the

same type have the same DMX address, then they will mimic each other's

behaviour. Incorrect settings will result in unpredictable responses to the

lighting controller.

Setting the DMX address

resistant mechanical fasteners suitable for the location.

Two quarter-turn brackets are supplied with the fixture if it is to be flown above

the ground. Remove the floor stand/base and rig the fixture to a support truss

or structure using the supplied brackets and suitable clamps.

WARNING!

The fixture can be tilted from 0° - 190°. To adjust the tilt angle, loosen the two

tilt screws, one of each side of the fixture, tilt the fixture to the angle required

and re-tighten the screws.

CAUTION: If the fixture has been operating, always allow it to cool for 15

minutes before handling.

6. Connecting AC Power

The fixture can operate on any 100–240 V, 50/60

Hz AC mains power supply. It draws approximately

2 amps at full power. For permanent installation,

have a qualified electrician wire the mains cable

directly to a suitable branch circuit.

The junction's ingress protection (IP) rating must be suitable for the location.

Fasten a safety cable (not shown) between

the support structure and the attachment

point on the fixture. The safety cable must

be able to bear at least 10 times the weight

of the fixture.

Always secure an elevated fixture with a safety cable as backup.