ARTFOX Lighting Matrix Beam 5.5 Gebruikershandleiding - Pagina 6
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} ARTFOX Lighting Matrix Beam 5.5. ARTFOX Lighting Matrix Beam 5.5 9 pagina's.
Pagina afdrukkenENTER button and the display will blink. Use the DOWN and UP button to select
(display on) or
(display off) mode. Once selected, press the ENTER button to setup
or exit menu mode without any change after 60 seconds. Back to the functions without any
change press the MENU button again.
Display Inverse
Press the MENU button until
select
(normal) or
(inverse). Back to the functions without any change
press the MENU button.
Self-Test
Press the MENU button up to when the
button and the unit will run the built-in programmer for self-test. To go back to the functions
press the MENU button.
Fixture Hours
Press the MENU button up to when the
button and the display will show the number of working hours of the unit. To go back to the
functions press the MENU button.
Software version
Press the MENU button up to when the
button and the display will show the version of software of the unit. To go back to the
functions press the MENU button.
5. How To Control The Unit
You can operate the unit in three ways:
1. By master/slave built-in preprogram function
2. By easy controller
3. By DMX controller
is blinking on the display. Press the ENTER button to
is blinking on the display. Pressing ENTER
is blinking on the display. Pressing ENTER
is blinking on the display. Pressing ENTER
10A
No need to turn the unit off when you change the DMX address, as new DMX address
setting will be affected at once. Each time you turn the unit on, it will show "
display. After that the unit will be ready to receive DMX signal or run the built in programs.
5.1 Master/Slave Built In Preprogrammed Function
By linking the units in master/slave connection, the first unit will control the other units to
give an automatic, sound activated, synchronized light show. This function is good when you
want an instant show. You have to set the first unit in master mode and select
(random show),
(show 1) or ...or
have nothing plugged into it, and Its master LED will be constantly on and sound LED will
flash to the music.
5.2 DMX Controller
Using universal DMX controller to control the units, you have to set DMX address from 1 to
512 channel so that the units can receive DMX signal.
Press the MENU button up to when the
button and the display will blink. Use DOWN and UP button to change the DMX512 address.
Once the address has been selected, press and keep ENTER button pressed up to when
the display stops blinking or storing automatically 8 seconds later. To go back to the
functions without any change press the MENU button again. If you use please refer to the
following diagram to address your DMX512 channel for the first 4 /2 units.
6. DMX512 Configuration
1-CH mode:
(show 8). Its DMX input jack will
is showing on the display. Pressing ENTER
11A
" on the