ARTFOX Lighting FLEX BEAM K8 Gebruikershandleiding - Pagina 9

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} ARTFOX Lighting FLEX BEAM K8. ARTFOX Lighting FLEX BEAM K8 15 pagina's.

4. How to Control the Unit

You can operate the unit in three ways:

1. By master/slave built-in preprogram function

2. By DMX controller

No need to turn the unit off when you change the DMX address, as new DMX address setting will

be affected at once. Each time you turn the unit on, it will show "BEAM-K8" on the display. After

that the unit will be ready to receive DMX signal or run the built in programs.

By linking the units together in master/slave, the first unit (the master) will control the other units

(the slave) to give an automatic, sound activated, synchronized light show. This function is good

when you want an instant show.

To set the first unit as a master, press the ENTER button to show the MASTER MODE on the display.

To set the unit as a slave, press the ENTER button to show SLAVE MODE on the display.

To set the DMX address, press the MENU button to show DMX Address on the display. Press the

ENTER button. Use the DOWN and UP button to change the DMX address. Once the address has

been selected, press the ENTER button to setup, to go back to the functions without any change

press the FUNCTION button. Press the FUNCTION button to exit the menu mode.

Please refer to the following diagram to address your DMX512 channel for the first 4 units.

Channel Mode

1 channel

7 channels

13 channels

Unit 1

Unit 2

Unit 3

Unit 4