EDIC-mini Tiny+ A77 Korte bedieningshandleiding - Pagina 5
Blader online of download pdf Korte bedieningshandleiding voor {categorie_naam} EDIC-mini Tiny+ A77. EDIC-mini Tiny+ A77 8 pagina's.
Ook voor EDIC-mini Tiny+ A77: Bedieningshandleiding (20 pagina's)
Pagina afdrukken
Attention: When installing batteries, observe the polarity (see marking on the recorder's
case). Inappropriate installing of battery may lead to failure of the recorder system,
which is not covered by the Warranty. Do not store the recorder for a long time with a
battery inserted, as the battery may leak and lead to recorder failure, and that is not
covered by the Warranty.
For recorders with rechargeable battery, first charge the battery. To do this, gently and
without strain follow the correct polarity, connect the recorder to the USB adapter, which
is in the delivery set, aligning the mark on the recorder with the one on the adapter.
Connect the adapter to the USB port of the PC or charger device, e.g. of a mobile phone,
with the output voltage of 5V and a USB connector. During charging, the LED flashes
rarely (interval of 5 seconds), and after charging has been completed, it starts flashing
frequently. Full charging takes approximately 2.5 hours.
Please note: In order to avoid deep discharge and related damage of the rechargeable
battery, the recorder must be charged at least once a month. The failure of the
battery due to its deep discharge is a violation of the rules of operation. In case of a
complete battery discharge, the procedure to restore the operation of the Recorder
described in full operation manual.
Important!
To prevent deep discharge and related damage of the rechargeable battery, disconnect
USB adapter from the Recorder after disconnecting adapter from PC. Use only the USB
adapter included in the delivery set. Using the USB adapter of third party may cause
the recorder's malfunction.
For recorders with external power supply – switch the recorder to OFF position and
then connect DC power supply (3.6-6V) to pins 1 (minus, gold colored wire) and 2
(plus, red colored wire) of the cable coming from the Recorder. If the voltage source
is represented by a Li-Pol battery, the connected pins 2 and 3 (green colored wire)
of the cable can provide battery charge with the current of 100mA (provided the
recorder is connected to the adapter, and the adapter is connected to the USB).
5