EDIC-mini CARD24S Bedieningshandleiding - Pagina 5

Blader online of download pdf Bedieningshandleiding voor {categorie_naam} EDIC-mini CARD24S. EDIC-mini CARD24S 8 pagina's.

• double flashes indicate average battery charge;

• triple flashes mean the battery is low and the Recorder must be charged.

When there is an end of recording, or after moving to the end of it using navigation functions, playback stops,

and the green LED starts flashing frequently. After that, if there are no buttons pressed for 10 seconds, the

Recorder switches to standby mode.

Navigation in Playback Mode

Enter Playback Mode.......... Press PLAY button once

Quit Playback Mode........Press both buttons simultaneously once

Go to the beginning of current record.............Press the REC button once

Go to the end of current record.......Press the PLAY button once

Go to the beginning of the previous record....... Press the REC button twice

Go to the beginning of the next record....... press the PLAY button twice

Go to the beginning of the first record.....Press the REC button thrice

Go to the beginning of the last record........... Press the PLAY button thrice

Voice Activation System (VAS)

Recording by sound level can be activated and adjusted via configuration file. If the function of sound level

recording is on, then when switching to record mode, the Recorder does not start recording immediately, but

needs to check sound level, blue LED will be flashing frequently. After the sound appears, its level exceeding

threshold specified in configuration file, the Recorder starts recording. Red and green LEDs start flashing

simultaneously, the number of flashes corresponding to battery charge level and free memory capacity,

similar to the record process.

If there is no sound, the Recorder continues recording for the time set in the configuration file. After that the

Recorder stops recording.

Sound check can be continuous, or periodical. During periodic testing, current consumption is reduced, but

sounds that fall between the checks are not recorded. During recording, the Recorder checks sound level

continuously, regardless of check regularity configured. While checking sound level, there are short blue LED

flashes with the interval of 3 seconds.

While periodic testing with the interval from 15 to 120 seconds, the LED will flash right at the moment of

testing, i.e. once in 15, 30, 60 or 120 seconds with the interval of about 6 seconds.

Timer Recording

The Recorder has 4 timers to automatically start recording at the preset time.

Timers are enabled and configured via configuration file (CONFIG_CARD24.INI).