dji Zenmuse H3-3D Gebruikershandleiding - Pagina 16

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} dji Zenmuse H3-3D. dji Zenmuse H3-3D 18 pagina's.

Pagina afdrukken

Appendix

Troubleshooting

Problem
Gimbal keeps drifting
after initialization.
The gimbal axes are
not level.
Unable to determine
gimbal orientation.

Settings When Using the A2 Flight Control System

Users should configure the H3-3D's pitch control in the A2 assistant when using the A2 Flight
Control System. Map the H3-3D to two channels on the transmitter as shown in the following
diagram. DJI recommends the use of a knob switch or a stick with spring back function for tilt
control, and a 2-position switch for MODE.
16
©
2014 DJI. All Rights Reserved.
Cause
1. The transmitter trims value is
beyond the acceptable limit.
2. The GCU is disconnected from the
flight control system.
3. The gimbal is not mounted correctly.
Factory calibration error.
BVR (beyond visual range) flight.
Zenmuse Channels
ROLL
PAN
TILT
MODE
SHUT
AUX1
AUX2
AUX3
Solution
1. Adju
st the transmitter trims value.
2. Connect the GCU and flight control
system.
3. Ensure the gimbal is mounted so it
is parallel with the aircraft, and the
pointing towards the nose.
camera is
Contact your local dealer or DJI
customer service for assistance.
Use a wireless video transmission
module.
Unmapped
REV
0
REV
Unmapped
0
REV
Unmapped
0
Unmapped
REV
0
REV
Unmapped
0
REV
Unmapped
0
Unmapped
REV
0
Unmapped
REV
0