dji Inspire 1 Snelstarthandleiding - Pagina 7
Blader online of download pdf Snelstarthandleiding voor {categorie_naam} dji Inspire 1. dji Inspire 1 11 pagina's.
Ook voor dji Inspire 1: Snelstarthandleiding (10 pagina's), Gebruikershandleiding (20 pagina's)
Pagina afdrukken
5. Preparing the Remote Controller
Tilt the Mobile Device Holder to the desired position then adjust
the antennas as shown. The strength of the remote controller
signal is different when the antenna position is different.
The transmission signal between the aircraft and remote
controller will perform best when within the optimal
transmission range. If the signal is weak, fly the aircraft
closer to you to achieve optimal signal performance.
If you have purchased an Inspire 1 with dual remote controllers, the Master remote controller will connect to the aircraft
automatically when powered on. Master/Slave mode is disabled by default. Activate it and set it up through the DJI Pilot
app. The Master remote controller's Status LED will show solid green when it connected to the aircraft. The Slave
remote controller's Status LED will show solid blue when it is connected to the Master controller.
Connecting the Master remote controller to the Slave remote controller:
On the Master remote controller, launch the DJI Pilot app and go to the Camera page. Then tap
screen to enter the remote controller settings window. Tap "Activate Master/Slave Mode"and select "Master". Then
enter your desired connection password for the "Slave" remote controller.
On the Slave remote controller, select "Slave " and tap "Search" to find the Master remote controller. Select the "Master"
remote controller from the "Master RC List" and input the connection password.
Do not use other 2.4GHz devices at the same time to avoid signal interference.
●
6. Preparing the Aircraft
The aircraft is in Travel Mode during delivery. Follow these steps to change it
to Landing Mode before your first flight:
Insert the Intelligent Flight Battery into the battery compartment.
1
Power on the remote controller and the Intelligent Flight Battery.
Toggle the Transformation Switch up and down at least four times. Repeat
to change aircraft to Travel Mode.
Power off the aircraft before mounting the gimbal and camera.
1
If you have purchased the dual remote controller version, you must use the Master remote controller to deactivate Travel Mode.
●
Strong
Weak
2
1
3
2
Press the button on the side of the Mobile
1
Device Holder to release the clamp.
Place your device onto the clamp and adjust
the clamp to hold it securely.
Connect your mobile device to the remote
controller with a USB cable. Plug one end of
the cable into your mobile device, and the
other end into the USB port on the back of
the remote controller.
3
on the top of your
Travel Mode
Landing Mode