dji Inspire 1 Pro Snelstarthandleiding - Pagina 7
Blader online of download pdf Snelstarthandleiding voor {categorie_naam} dji Inspire 1 Pro. dji Inspire 1 Pro 10 pagina's.
Ook voor dji Inspire 1 Pro: Snelstarthandleiding (11 pagina's), Snelstarthandleiding (11 pagina's), Gebruikershandleiding (10 pagina's)
Pagina afdrukken
6. Preparing the Remote Controller
Tilt the Mobile Device Holder to the desired position then adjust
the antennas as shown. The strength of the remote controller
signal is different when the antenna position is different.
Strong
The transmission signal between the aircraft and remote controller will
perform best when within the optimal transmission range. If the signal is
weak, fly the aircraft closer to you to achieve optimal signal performance.
1
Using DJI Focus
Use DJI Focus to remotely adjust the camera lens
(e.g. continuous manual focus). Refer to "Inspire 1
Pro User Manual" or "DJI FOCUS User Manual" for
more information.
Do not use other 2.4GHz devices at the same time to avoid signal interference.
7. Installing the Camera
Ensure the camear body cap, the lens cap and rear cap are removed. Align the two Lens Mount Indexes on the
1
camera body and camera lens, and insert the camera lens into the body of the camera.
Rotate the camera lens clockwise until you hear a click.
Rotate the Lens Lock anticlockwise to lock it.
Mount the Balancing Ring (or a filter) and the Lens Hood. Insert the Micro SD card.
1
Rotate the Lens Lock anticlockwise to tighten the junction between the lens and camera body
when using the camera.
Rotate the Lens Lock clockwise to loosen the junction between the lens and camera body when
attaching and detaching the camera.
Always set the camera lens to AF mode.
While holding down the Lens Release Button, rotate the camera lens anticlockwise to detach it.
Mount only a lens filter or Balancing Ring on the camera.
Weak
Press the button to release the clamp.
1
2
Place your device onto the clamp and adjust the clamp to
hold it securely.
Connect your mobile device to the remote controller with a
USB cable.
If you have purchased an Inspire 1 Pro with dual remote
controllers, the Master remote controller will connect to the aircraft
automatically when powered on. Master/Slave mode is disabled
by default. Activate it and set it up through the DJI GO app.
Connecting the Master remote controller to the Slave remote
controller: On the Master remote controller, launch the DJI GO
3
app and go to the Camera page. Then tap
your screen to enter the remote controller settings window.
Tap "Activate Master/Slave Mode"and select "Master". Then
enter your desired connection password for the "Slave"
remote controller. On the Slave remote controller, select
"Slave " and tap "Search" to find the Master remote controller.
Select the "Master" remote controller from the "Master RC
List" and input the connection password.
2
on the top of
Balancing Ring or Filter
Lens Hood
4