FITKIT FT100S Gebruikershandleiding - Pagina 10

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} FITKIT FT100S. FITKIT FT100S 13 pagina's.

Pagina afdrukken

Translation of Error Codes

Fault

Failure Description

code

Communication

when the power is on, the

connection

controller and the console is

abnormal.

No signal from motor.

Over current protection:

controller detects the current to

be over 6A for more than 3

seconds.

Explosion-proof impact

protection: the abnormal

voltage or motor cause the

faulty of circuit that drive the

motor.

Without putting the safety Key

Abnormal:

between

lower

working,

the

lower

Possible Cause: the communication between the lower controller

and console is blocked, check each joint between the controller

and console, ensure that each core is fully plugged in. Check the

connection line, replace it if it's damaged.

Possible Cause:

Check the motor cable to see whether it is connected well or not, if

not, connect the motor wire again.

Check the motor cable to see whether it is damaged or has a burnt

smell, if yes, replace the motor.

Check the speed sensor to see whether it is correctly installed or

damaged

Possible Cause:

Overloading leads to excessive current, and the system stop out of

self-protection, or some part is stuck, causing the motor to stop.

Adjust the treadmill and restart it. Check if there is liquid or burnt

smell while the motor is running, if yes, replace the motor; check

if the controller has a burned smell, if yes, replace the controller;

check the power supply voltage, if it does not match the

specifications, change into correct voltage and test the machine

again.

Possible Cause:

Check if the power supply voltage is 50% lower than normal

voltage ，use the correct voltage and test the machine again；

check if the controller has a burnt smell and replace the controller;

Check if the motor cable is connected and connect the motor wire

again.

Put the safety key on the right place.

Fault Handling