Akku Vision e-bike vision 10040 Handleiding/veiligheidsaanwijzingen - Pagina 7
Blader online of download pdf Handleiding/veiligheidsaanwijzingen voor {categorie_naam} Akku Vision e-bike vision 10040. Akku Vision e-bike vision 10040 9 pagina's. For ebv e-bike battery, compatible to bosch* active (plus) / performance (cx) drive system with 36 v
Pagina afdrukkenThe Charging
Your new battery can be charged with the original charger, which was included when you bought your ebike.
When using the E-Bike Vision charger in combination with the additional available charging adaptor or when
using the original charger, you can charge your battery inside or outside of the ebike.
Requirements for charging within the ebike
The drive system must be turned off. Open the cap of the charge plug, which is located with the frame or close to
the battery.
Requirements for charging outside the ebike
Charging outside the ebike is started by turning off the drive system.
Please wait until all LEDs turned off. Now you can take out the battery by opening the lock and taking out the battery
and charge it inside your apartment or garage in your presence.
Start of charging process with the original charger
1. Connect the charger to the mains.
2. Make sure that none of the battery LEDs are lighting when it's not mounted in the eBike.
3. Now plug in the charging connector of the charger to the battery.
4. Charging process start. The LEDs of the battery corresponding to its current state of charge begins to flash.
5. If charging does not start immediately, please push the capacity indicator button of the battery and wait
until LEDs are lighting.
6. If the battery is almost fully charged (4 LEDs are lighting and the 5th is flashing), the fan will not start turning
under certain circumstances, because the charger switches immediately into the so-called constant voltage
mode. Within this mode, the power consumption of the charger is that low that the running of the fan is not
necessary. Furthermore, the fan will also turn off towards the end of charging process, as it is no longer
needed in constant voltage mode.
Naming of LEDs
During charging, the capacity is indicated by lighting and flashing of the battery's LEDs as follows:
LED 1 flashing:
LED 1 lighting and LED 2 flashing:
LED 1,2 lighting and LED 3 flashing:
LED 1,2,3 lighting and LED 4 flashing:
LED 1,2,3,4 lighting and LED 5 flashing:
LED 1,2,3,4 and 5 lighting:
Date 2022-04-19
Index 02
0 – 20 % charged capacity
21 – 40 % charged capacity
41 – 60 % charged capacity
61 – 80 % charged capacity
81 – 99 % charged capacity
100 % charged capacity
Akku Vision - Manual EBV E-Bike Battery compatible to Bosch* Active / Performance
*Bosch is a trademark of the Robert Bosch GmbH
S. 7 / 9