Fitness Technology 400S+ Handmatig - Pagina 5
Blader online of download pdf Handmatig voor {categorie_naam} Fitness Technology 400S+. Fitness Technology 400S+ 10 pagina's. Performance force plate
Pagina afdrukken
FORCE PLATE 400 Kg Capacity
Installation:
1. Carefully unpack the platform by lifting it out the end of the transport carton. Make
sure all items are present. (Report any discrepancies immediately.)
2. Place the platform onto a flat stable surface.
3. Install each foot into the load cell holes on the four corners of the platform by
rotating the feet to the right. (right hand thread) Adjust height as show below.
4. Connect the USB communication cable as shown below by removing the plug
allowing access to the communications port. (See photos below)
5. The Platform is now ready for use.
6. Install the communications software and the processing software following the
instruction for each module
7. The XPV7 PCB Electronics Module will automatically identify any cable faults.
Should this happen make sure the communication cables are properly installed. If
communication failure continues, then replace the USB cable.
8. For any other problems contact our office for further instructions.
USB and PT5A position Transducer Cable Connections
Fitness Technology, 21 Bishop Street, Skye SA 5072 Australia
Postal Address: PO Box 139 Fullarton 5063 Tel: +61 8 8331 9229
Copyright: Fitness Technology, Adelaide, Australia 3rd Feb 2020 Issue 1.00, 3rd Feb 2020
FORCE PLATE 1000 Kg
Capacity
www.fittech.com.au E [email protected]
USB Connector
US8/8 Plug Cat5e cable
Pin 2 = PT5A IK Pot V Signal
Pin 4 = USB +5V
Pin 6 = USB Gnd.
Pin 7 = MBU V Signal.
4
Mob: 0418 815 400.