Articona 833158 Gebruikershandleiding

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Articona 833158. Articona 833158 3 pagina's. 10/100/1000base-t to 1000base-x standalone
Ook voor Articona 833158: Gebruikershandleiding (3 pagina's)

Pagina afdrukken

Trademarks

Contents subject to revision without prior notice.

All other trademarks remain the property of their owners.

This publication may not be reproduced as a whole or in part, in

any way whatsoever unless prior consent has been obtained

from the owner.

FCC Warning

The converter has been tested and found to comply with the

limits for a Class A digital device, pursuant to Part 15 of the

FCC Rules. These standards are designed to provide

reasonable protection against harmful interference when this

device is operated in a commercial environment. This device

generates, uses, and can radiate radio frequency energy and

may cause harmful interference to radio communications

unless installed in accordance with this User's Guide.

Operation of this device in a residential area is likely to cause

harmful interference which will make the user responsible for

the appropriate remedial action at his / her own expense.

CE Mark Warning

These is a Class A product. In a domestic environment this

product may cause radio interference in which case the user

will need to consider adequate preventative methods.

1. Checklist

The package should contain the following items:

- Converter

- AC-DC Power Adapter

- User's Guide

Please notify your sales representative immediately if any item is

missing or damaged.

2. Overview

This converter is designed to meet the massive needs for Gigabit

network deployment and able to extend a copper based Gigabit

network via fiber cable to a maximum distance up to 80KM. It is

fully compliant with IEEE802.3, 802.3u, 802.3ab and 802.3z

standards. It can be installed into a Converter RACK. The

installation

and

operation

procedures

straightforward.

Operation status can be locally monitored

through a set of Diagnostic LED located in the front panel.

Major Features:

- Auto-Negotiation in TX port

- MDI/MDIX Auto-Crossover supported

- Support Flow Control

- Support Link Alarm

- Support Jumbo Frame 9K bytes (under 10,100,1000Mbps)

- Store and Forward Switching Mechanism

- Support Auto & Force mode configuration

3. Installation

- Attach fiber cable from the Converter to the fiber network.

The fiber connections must be matched – transmit socket to

receive socket.

- Attach a UTP cable from the 10/100/1000BASE-T network

to the RJ-45 port on the Converter.

- Connect the power adapter to the Converter and check that

the Power LED lights up. The TX Link/Act and F/O Link/Act

LEDs will light up when all the cable connections are

satisfactory.

Figure 2. Front Panel of WDM fiber/SFP model

are

simple

and

4. DIP SWITCH Setting

Figure 1. Front Panel of dual fiber model

Figure 3. Rear Panel