Artillian 1RMCSM Installatie- en gebruikershandleiding - Pagina 2

Blader online of download pdf Installatie- en gebruikershandleiding voor {categorie_naam} Artillian 1RMCSM. Artillian 1RMCSM 5 pagina's. Chainsaw mount

Pagina afdrukken

ATTACH TO MOUNTING BAR:

Note: The Artillian ROPS Mounted Toolbar is designed to

hold multiple accessories at one time. If placed appropriately,

up to 3 separate accessories may be possible. For example,

the Chainsaw Mount, Fuel Can Holder, and Beverage Cooler

Holder were designed to fit on the toolbar simultaneously.

1. Figure 1 shows a chainsaw mount installed onto an

Artillian ROPS Mounted Tool Bar.

2. To install the chainsaw mount, rotate both cam

levers UP, then place onto the Tool Bar. See fig. 2.

Note: if the Cam Lever Latches do not sit flush on the Tool Bar, one

of the clamp plates may not have been fully open. Simply remove the

chainsaw mount, rotate the cam levers up and tilt the chainsaw

mount away from you to ensure the clamp plates are fully open, then

reinstall on the Tool Bar.

3. To secure the chainsaw mount to the Tool Bar,

rotate both cam levers DOWN until they cam over.

See fig. 3.

NOTE: For additional security, the chainsaw mount can be locked to

the Tool Bar by inserting a padlock through the holes in the mounting

bracket where shown in fig. 3.

4. To remove the chainsaw mount from the Tool Bar,

rotate both cam levers UP, then lift the chainsaw

mount.

FEATURES AND OPERATION

1. For optimal functionality, the cam lever latches are

factory assembled with some friction between the

cam lever and the housing. This ensures the cam

lever doesn't accidentally flip closed while the user

attempts to install it on the bar. If the cam levers

loosen up over time, simply tighten the nut and bolt

that secure the lever to the housing until the

desired resistance on the cam lever has been

achieved.

2. To install the chainsaw into the mount, pull the

quick release pin and rotate the chainsaw mount's

cam lever down. See fig. 4.

3. Slide the chainsaw into the mount, per fig. 5.

Fig. 5 (installing chainsaw, slide chainsaw into place)

FEATURES AND OPERATION

Fig. 1 (attaching the chainsaw mount)

rotate both cam levers up

to install the chainsaw mount

Fig. 2 (cam lever in the open position)

Fig. 3 (cam lever in the closed position)

Rotate

Lever Down

Cam Lever

Fig. 4 (installing chainsaw, remove Q.R. pin)

padlock holes

rotate both cam levers

down to secure the

chainsaw mount

Bungee Cord

Mounting Holes

Q.R. Pin

2 of 5