djpower H-S6 Gebruikershandleiding - Pagina 12

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} djpower H-S6. djpower H-S6 16 pagina's.

5.1.5

W-7 wireless remote control function (standard)

This function is used to control the machine work remotely. The remote control can reach

more than 40 meters in the open space. First turn on the machine, then turn on the remote

control function and the remote control transmitter is matched, so the remote control function

is effective.

After the wireless receiver has been tested, it will be fixed on the panel of the H-S6, please do

not try to pull it out.

There are four buttons on the remote control. Press the "A" button to start the machine, press

the "B" button to stop the machine, press the "C" button to reduce the output, and press the

"D" button to increase the output.

H-S6 can match multiple remote control transmitters. This is to allow individual control from

machine to machine without being affected by other wireless transmitters. The following

explains how this function works.

5.1.6

Identify the wireless transmitter

When the machine is powered on, and the last time the remote control function setting page

is set to ON, the LCD controller will display "Wireless Setup", if this state appears, it means that

the wireless transmitter can be paired. When pressing the button on the wireless transmitter (it

needs to stay for at least 1 second), if the backlight of the LCD controller flashes twice, it

means that a wireless transmitter has been recognized and stored. A machine can only

recognize up to 60 wireless transmitters.

•

If multiple wireless remote control transmitters have been identified, now to make clear the

matching remote control data, the operation is as follows:

•

On the "Clear remote control data" page, press the button "ENTER", the screen displays

"Data clearing...", and after a few seconds, the screen displays "Data clearing complete". At

this time, it means that the previously matched remote control transmitter data has been

cleared, and it needs to be re-matched before it can be controlled.

Wireless remote

Wireless receiver