djpower TOPCAT HF-90 Gebruikershandleiding - Pagina 9

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} djpower TOPCAT HF-90. djpower TOPCAT HF-90 13 pagina's. Flame machine

Pagina afdrukken
Note:
1. Safety distances for Vertical flame machine are indicated in above picture. At least 5m in all projection directions, at least 5m to the other
sides of the device. In order to indicate correct direction, please place the top panel correctly.
2. Open the top cover of the flamer from the "OPEN" position, take out the flame fluid can, and add the fuel.
3. The nozzle is still hot after the flamer worked, to prevent burns, do not touch, wait for natural cooling.
5.4.2.
Quick Operation Sheet
Immediately upon receiving the machine, carefully unpack the carton, check the machine received in good condition. Ensure safety operation
of machine, please do following below operation procedures when operate flame machine.
Schematic
Operation
diagram
step
1
Installation
Locate safety
2
lock at TEST
MODE
3
Fueling
Power and DMX
4
cable
connection
Switch ON the
5
machine
Set DMX
6
address
7
Pressurize
Check device
8
status in TEST
MODE
9
Pressure Relief
Switch safety
10
lock to USER
MODE
11
Pressurize
12
Firing
13
Pressure Relief
Switch
14
lock
to
MODE
15
Power off
Explanation
The device can only be placed horizontally, if placed on truss, please locked with extra safety cables.
Before operate machine please locate safety lock at TEST MODE.
Under TEST MODE, operator can test the rotation of nozzle, but the fuel ejection function is disabled
to prevent firing.
Under USER MODE: the device can run normally. Please strictly follow the safety distance requirement.
Human beings, animal or flammable objects shall be away from the danger area.
Take out the flame fluid can and add fuel; carefully put it back into the cabinet to avoid spilling; ensure
that the tube is placed in the fluid can; tighten the container cap. Please use the designated suitable
fuels.
110V/220V main power supply （ See the item marked on the main label of the device ）
Please confirm safety lock located at TEST MODE before switch on the unit.
The vertical flame machine can switch between 2 channel or 6 channel mode.
Under DMX control: Channel 6= 50~200.
Reconfirm safety lock located at TEST MODE before test. In this status, the nozzle will rotate, and
igniter will be activated, but there is no flame effect because no fuel output. In case DMX control is
used to test the sequence, It is suggested to set CH1 at 128, so that nozzle stays at straight up
position after firing.
Under DMX control: Channel 6= 0~49 or 201~255.
Before switching to USER MODE, Please strictly follow the safety distance requirement, make sure no
human beings, no animal or no flammable objects are within the danger area.
Under DMX control: Channel 6=50-200.
Under DMX control: Channel 3=255.
Relief pressure when show finished or Wave flame machine will not be used for a long period. Under
DMX control: Channel 6= 0~49 or 201~255.
safety
TEST
Guarantee safety use for next time.
Power off Wave flame machine, tear down power cable and DMX cable, pack the device when it is
cooled down.
- 7 -