Altronix AL602ADA220J Installatiehandleiding - Pagina 5
Blader online of download pdf Installatiehandleiding voor {categorie_naam} Altronix AL602ADA220J. Altronix AL602ADA220J 16 pagina's. Nac power extender
Pagina afdrukken
Class A, Style Z Class B, Style W, X, Y, SW1 and SW2 Settings:
• For all Class B, Style W, X, Y, hookups SW1 and SW2 on the AL800LGK9E logic board must be turned OFF .
For all Class A, Style Z hookups SW1 and SW2 on the AL800LGK9E logic board must be turned ON .
Function
Input to Output
Follower Mode
Temporal Code 3 Mode
Steady Mode
For the above modes DIP Switch 4 determines which Input controls the corresponding output:
Switch 4 in the ON position causes output(s) to be controlled by Input 1.
Switch 4 in the OFF position causes output(s) to be controlled by Input 2.
Note: It is required to control visual notification appliances (strobes) via
Input 1 (IN1) and audible notification appliances (horns) via Input 2 (IN2).
This allows audible notification appliances (horns) to be silenced while visual
notification appliances (strobes) continue to operate. The FACP must be capable
of a visual annunciation to the silencing status of the output or zone(s) to which the
AL602ADA220J (NAC Power Extender) is connected.
Function
Amseco
Sync Mode*
Faraday
Sync Mode*
®
Gentex
Sync Mode*
Gentex is a registered
trademark of
Gentex Corporation .
®
System Sensor
Sync Mode*
System Sensor is a
registered trademark of
Honeywell .
CooperWheelock
®
Sync Mode*
CooperWheelock is a
registered trademark of
Cooper Wheelock .
*Note: The AL602ADA220J will only synchronize horns, horn/strobes and strobes that contain synchronization
capability . Contact signal manufacturer for more detailed info (see Appendix A, pgs. 11-13) .
The same synchronization mode must be selected for all outputs .
AL602ADA220J
Output Programming Selection Table:
Outputs must be programmed independently (OUT1 - OUT4)
Switch Positions
ON
OFF
1
2, 3
3
1, 2
1, 2, 3
Sync Mode Selection Table:
Switch Positions
ON
OFF
1, 3,
2
4
2, 4
1, 3
1, 2,
3, 4
1, 2, 4
3
2, 3, 4
1
Descriptions
Output follows signal it receives from the corresponding
input (i .e . FACP Sync module - maintains synchronization
of notification appliance circuit) .
Enables Temporal Code 3 signal generation output .
This mode will accept a steady or a pulsing input .
A steady output signal will be generated .
This mode will accept steady or pulsing input .
Descriptions
This mode is designed to work with the Amseco series of horns,
strobes, and horn/strobes to provide a means of synchronizing
the Temporal-coded horns, synchronizing the flash timing of the
strobe, and silencing the horns of the horn/strobe combination over
a two-wire circuit while leaving strobes active .
This mode is designed to work with the Faraday series of horns,
strobes, and horn/strobes to provide a means of synchronizing the
Temporal-coded horns, synchronizing the flash timing of the strobe,
and silencing the horns of the horn/strobe combination over a two-
wire circuit while leaving strobes active .
This mode is designed to work with the Gentex
strobes, and horn/strobes to provide a means of synchronizing
the Temporal-coded horns, synchronizing the flash timing of the
strobe, and silencing the horns of the horn/strobe combination
over a two-wire circuit while leaving strobes active .
This mode is designed to work with the System Sensor
horns, strobes, and horn/strobes to provide a means of synchroniz-
ing the Temporal-coded horns, synchronizing the one-second flash
timing of the strobe, and silencing the horns of the horn/strobe
combination over a two-wire circuit while leaving strobes active .
This mode is designed to work with the CooperWheelock series of
horns, strobes, and horn/strobes to provide a means of synchronizing
the Temporal-coded horns, synchronizing the one-second flash tim-
ing of the strobe, and silencing the horns of the horn/strobe combina-
tion over a two-wire circuit while leaving strobes active .
AL800LGK9E Board
Output DIP Switches
INPUT SELECT
TEMPORAL
STROBE SYNC
IN>OUT SYNC
®
series of horns,
®
series of
- 5 -