Artison SB-1 Installatiehandleiding - Pagina 7

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Artison SB-1. Artison SB-1 8 pagina's. Soundbar

MOUNTING AND WIRING THE SOUNDBAR
1.
The SoundBar comes with a Main Bracket which is attached to the speaker cabinet via a
thumbscrew on either end. This Main Bracket will attach to the ends of the Television
Mounting Brackets.
NOTE: The Main Bracket may also be used to directly wall mount the SoundBar, with
the appropriate wall mounting hardware utilize the slots in the back of this part for this
method. The Main Bracket also functions as a table-top stand for the speaker, simply
with placement of the foam padded side down on the table.
2.
Remove the Main Bracket from the SoundBar by loosening the thumbscrews in a
counter-clockwise direction.
3.
Carefully slip the Main Bracket off of the LCR.
4.
Locate the horizontal center of the display.
5.
Insert the 4 x 3 mm Allen Head
loosely hold the Main Bracket in place, do not tighten them yet. Center the Main Bracket on
the television set. Then tighten the Bracket to Bracket Screws. See Figure 4.
NOTE: If installing the SoundBar on the top of a television, please refer to Figure 3.
6.
Holding the SoundBar, attach the three speaker wire pairs to the binding posts on the rear of
the SoundBar. The red terminal is the positive terminal and the black terminal is the negative
terminal. The outer sets of binding posts are Left and Right respectively and the center set of
binding posts is the Center Channel.
NOTE:
The SoundBar is a 3 channel (Left, Center and Right) passive loudspeaker
device and requires 3 discrete audio signals from an external multi-channel amplifier.
The speaker wire gauge required is dependent upon wire length run, 16 gauge is
suggested as the minimum size.
7.
Carefully slide the SoundBar onto the Main Bracket that is now mounted to the display.
8.
Use the knobs that you removed earlier to loosely re-attach the speaker. Slide the SoundBar
back and forth until the front edge is approximately 1/4" behind the front surface of the display.
Tighten the knobs to hold the speaker in place.
9.
Finally snap the grille over the speaker cabinet and slide the grille side to side until it is flush
with both edges of the flat panel's bezel.
Bracket to Bracket Screws (supplied in your Hardware Kit) to