DK2 Everest R-3 Gebruiksaanwijzing - Pagina 11

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} DK2 Everest R-3. DK2 Everest R-3 16 pagina's. Snow plow

TROUBLESHOOTING

Plow is not func oning:

1. Con rm the main power and control wire plugs are clean and properly connected

2. Con rm the control wire is properly connected to the hand held control.

3. Con rm that the main power inline breaker was not accidently tripped. Press the red bu on on top

and push the trip wing back in to reset

Not the rst three...

4. Do a quick test of the hand held control, standing between the snowplow and the vehicle on the

passenger's side unplug the grey control wire at the rubber plug assembly, leave the main power plug

connected, with the use of needle noise pliers perform the two oper ons shown below on the plow

side of the plug. Try raising rst and the pump should run, then lower.

To raise the plow...

A - If the plow operates there is an issue with the control or control wire, check the wire carefully to make sure it

is not cut or pinched, remove and reconnect the wire from the bo om of the hand held control, re-connect the

control wire to the plow and re-test.

To lower the plow...

En.11

v.190915