Artistic License Data-Lynx O/P Gebruikershandleiding - Pagina 10

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Artistic License Data-Lynx O/P. Artistic License Data-Lynx O/P 13 pagina's.

Pagina afdrukken

Troubleshooting

The fixtures are flashing

randomly when connected to

the Data-Lynx O/P.

When using a Data-Lynx

O/P the fixture seems to lose

DMX when set to high start

addresses.

Data-Lynx O/P powers up

but all the LED indicators are

flashing continuously.

I changed my IP address and

have lost all communication

with the Data-Lynx O/P.

All the LED indicators flash

three times when I change

the Sub-Net wheel selector.

I have connected a Data-

Lynx O/P directly to a

computer and there is no

communication.

I have a Data-Lynx O/P but I

want some to be inputs. Can

I use some gender changers

to make it an input?

An output port DMX LED is

flashing continuously.

I have connected 3 or more

Data-Lynx units in series and

the data seems to be delayed

from the first to the last.

Data-Lynx O/P User Guide

1. The common cause of this is that they are responding

to RDM data being transmitted by the Data-Lynx. If

they are DMX512 compliant they should ignore this

data. To overcome this, refer to the 'Jumper - Advanced

Configuration' section and link the jumper to disable

RDM. Alternatively this can be done via the web-

server.

1. Some older equipment cannot handle full rate DMX

refresh rates. This results in it working on lower start

addresses, but seeming 'steppy' on higher start

addresses. To overcome this, use the web-server DMX

settings page to slow down the refresh rate.

1. This means that the unit has gone into boot loader

mode. Uploading the latest firmware will allow the unit

to function normally.

1. If the IP address of a device is changed such that it is

out of the range the PC is on, you must then change

the PC IP address to match. If you still cannot discover

the device, you will need to reset all custom settings to

put it back into the default IP range (2.x.x.x).

1. If the Sub-Net value has been set remotely the front

panel wheel is ignored. The LEDs flash to indicate this.

1. Computer has incorrect IP address (IP address should

be in the range 2.x.x.x).

2. Incorrect network cable (should be a 'cross-over').

3. A firewall is blocking transmitted/received data packets

1. No, port configuration is a factory process.

1. When the port LED is flashing it means that the output

is merging two universes.

1. If several Data-Lynx units are connected in series

then the data from the control source has to be re-

transmitted to each one. The more in series, the longer

the delay. To overcome the delay use an ethernet

switch and connect all Data-Lynx units and control

sources to it.

Page 10