Artistic studio Artristic Studio Easel Gebruikershandleiding - Pagina 6
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Artistic studio Artristic Studio Easel. Artistic studio Artristic Studio Easel 15 pagina's.
Pagina afdrukkenHow To Prepare the T-Bar, Hub
and Tripod Before Attaching A Canvas
1
� Loosen the large centre tube locking-nut and raise the tube up about 20cm
(8 inches).
� Re-tighten the nut
2
� Unlock this knob and tilt
the Hub slightly backward,
then re-tighten the knob to
hold the Hub in that position
3
� Remove the two
clear plastic point
protector
caps
on each T-Bar
and place them
onto the storage
projections
on
the back of each
T-Bar
WARNING:
These pointed rods are not screws. Since
they are flat at the base of the points they will only penetrate
4mm into the wood.
10
4
� Now rotate
each
of
the
pointed
rods
backward until
only the 4mm
long points are
visible
How To Attach A Canvas To Your Artristic Easel
1
� Mark the back of your canvas frame in
the centre, equal distance from each of
the four sides.
3
� Lean your canvas against the front of
the two foam-sleeve covered tripod legs.
2
� If your canvas already has centered
cross supports there is no need to mark
those sides
4
� Lift canvas up and lower it down onto
the shelf of the centre T-Bar using the
mark you made (or a canvas support
strut) to guide you to the centre of both
the T-Bar shelf and the canvas
11