CustomWorks NITRO ROCKET KIT 0715 Handmatig - Pagina 5
Blader online of download pdf Handmatig voor {categorie_naam} CustomWorks NITRO ROCKET KIT 0715. CustomWorks NITRO ROCKET KIT 0715 16 pagina's.
Bag D
Bag D
Bag D
Bag D
Bag D
Rear Suspension
Rear Suspension
Rear Suspension
Rear Suspension
Rear Suspension
-Parts for
Step#1
3241
Qty 2
Bearing Carrier
-Parts for
Step#2
7211
Qty 2
CVD Coupling
-Parts for
Step#3
5249
Steel Turnbuckle
STEP #1
5230
4235
- Press 1226 Ball Bearings into the 3241 Bearing Carrier.
- Attach the Bearing Carrier to the Susp Arm using 4235
Susp Pin with (2) 1255 Spacers on each side of the
Bearing Carrier.
- NOTE: The Suspension Pin will pass thru the UPPER
hole in the Bearing Carrier.
- Retain the Susp Pin using 5230 E-Clips.
STEP #3
5205
1:1
1226
Qty 4
Ball Bearing
7214
Qty 2
Medium Dogbone
1:1
Qty 2
3241
1226
8122
4235
Qty 2
1:1
Rear Outer Susp Pin
7216
Qty 2
Rear CVD Axle
1:1
5235
Qty 4
7047
Ball Cup
Spacer
STEP #2
1255
7214
- Apply grease to the areas shown.
- Apply thread-lock (Loctite) to the set screw.
- Align the holes as shown so that the
7211 CVD Pin can pass thru the Bone,
Axle, and Coupling. Pin should be evenly
spaced in the DogBone.
-Tighten the Set Screw by angling the Bone
and Axle so the set-screw is able to be tightened.
- Attach the 8122 Ball Stud to the Rear Bulkhead
as shown using a 5217 Lock Nut.
- Slide a 1255 Spcaer onto the Ball Stud and
thread into the Bearing Carrier in the outer most
hole.
- Insert the CVD assembly by sliding the axle thru
the bearings.
- Slide (4) 7047 Shims onto the axle and retain
using the 7203 Roll Pin. Pin should be evenly
spaced in Axle.
8122
- Attach the Camber Link by snapping the Ball
7203
Cups onto the Ball Studs.
1255
1255
Qty 10
Spacer
1:1
7211
Qty 2
7211
Rear CVD Pin
CVD Set Screw
1:1
Qty 6
8122
Qty 4
7203
Ball Stud
Roll Pin
7211
(Pin)
XXXX
Qty 4
Ball Stud
7047
1:1
5230 Qty 24
E-Clip
1:1
Qty 2
Qty 2
5217
Qty 2
4-40 Lock Nut
7216
7211
(Coupling)
7211
(Set Screw)