Cutech 80100-CT Handmatig - Pagina 2

Blader online of download pdf Handmatig voor {categorie_naam} Cutech 80100-CT. Cutech 80100-CT 2 pagina's. Universal stand

Align holes on upper brace, long, with the holes on the upper leg piece. Insert two carriage bolts and

hand tighten using hex nuts.

Repeat the above step on the opposite side.

On the inside of the leg stand, place lower brace, short, on top of both the upper and lower leg pieces .

Insert two carriage bolts and hand tighten using hex nuts.

Repeat the above step on the opposite side.

Place one rubber foot on the bottom of each lower leg piece.

Using a wrench, securely tighten all hex nuts. This completes the leg stand.

(FOR 40100-CT/40100H-CT/40300H-CT/40700-CT/40160H-CT)

NOTE: The board (not included) may be required to be attached your machine to the stand. Prepare a

piece of 5/8 " to 3/4" thick plywood to the top dimensions of the stand (23 "x 14 ") or a bit larger. Place the

wood onto the stand . Fasten the wood in place to the stand with screws or bolts (not included). Use the pre

- bored holes in the stand's four corners, or bore new holes through the upper braces for better security.

SEE FIG 1 & 2.

WARNING!

TO AVOID serious injury, death, or damage to the machine. Do not mount any machinery to

the stand until the stand is completely assembled, do not run the machine until it's mount on the stand

securely.

Mounting holes in your machine line up with the four pre-bored holes in the stand's four corners, Just fasten

the machine onto the stand with nuts and bolts (not supplied). SEE FIG 3.

FIG 1

For technical support, email

MOUNTING THE BOARD TO THE STAND

MOUNTING PLANER TO THE STAND

(FOR 40200H-CT/40600H-CT)

FIG2

or call at 877-568-8879

FIG3