Alula RE107 Handmatig - Pagina 2

Blader online of download pdf Handmatig voor {categorie_naam} Alula RE107. Alula RE107 4 pagina's. Outdoor door/window sensor

Make sure to align the alignment marks on the sensor and magnet

when mounting. Finish by latching the sensor to the mounting

plate and tightening the cover-securing screw to secure the sensor

in place.

Removal Tamper

with rubber washer through the removal tamper screw hole in the

base and into the mounting surface. Remove the battery for access

to the removal tamper screw hole.

External Contacts

the back of the enclosure. A thinned area in the enclosure must be

punched out with a screwdriver to allow the wires through. After

routing and connecting the wires, reseal the hole with silicone

caulk.

• Do not use end-of-line resistors.

• Wire contacts to one or both outside terminals using the

center terminal as a shared common.

• The sensor defaults to use normally closed contacts (alarm

condition when contact is open).

• To reprogram external inputs, set both externals to the

desired non-alarm state and restart (remove and reinstall

battery) the device 3 times while holding the tamper

switch.

Pro Tips

Metal installs should include pre-drilling holes before using

screws to secure the mounting plate and magnet.

Wireless performance is optimized when mounted near the top

of the gate or door in a vertical orientation.

is implemented by screwing the provided screw

can be installed by routing the wires through

Removal tamper

screw hole

Thinned area for external

contact wires