Alula RE667 Handmatig - Pagina 8

Blader online of download pdf Handmatig voor {categorie_naam} Alula RE667. Alula RE667 12 pagina's. Slimline touchpad
Ook voor Alula RE667: Handmatig (12 pagina's), Handmatig (13 pagina's)

Pagina afdrukken

• Return to dashboard - specifies time of inactivity before Touchpad will automatically return

to dashboard

• Dock - specify the items to be displayed in the bottom dock

• Notifications - ability to turn on and off notifications on the system overview page

• Wi-Fi - connect via Wi-Fi if using cameras and user management features

• Temperature Scale - option for displaying

• Alula Cloud - must be logged into Alula Cloud as the account owner to use cameras and

user management features

• Power Off

• Panel (must enter code to access)

• Sensor Chime - enables or disables panel sensor chime mode (only available with Connect+)

• Quick Arm - arm the panel without entering your access code. Access code is still required

to disarm

• Users - manage device users directly from the touchpad (only the account owner can modify

users, internet access is required).

• Keypads - lists the panel's keypads

• Rename keypads by selecting an item on the list and holding it for 2 seconds

• Communication Test mode

• The Touchpad will begin testing communications and display "TESTING"

• After one minute, the Touchpad will show the result of the test which will be either

"GOOD," "FAIR," OR "POOR"

• If you get a "POOR" test result, try the test again from another location

• The table below lists the thresholds used to determine the outcome of the test

• If any statistic falls in the poor range, the test outcome is "POOR"

• If there are no poor statistics and any statistic is in the fair range, the outcome of the

test is "FAIR"

• If all statistics are in the good range, the outcome of the test is "GOOD"

Statistic

Wi-Fi Signal

Strength

Communication

Success Rate

Response Time

Average

• Check for updates - this will tell the panel to check for any system updates

• Z-Wave

• Join/Leave Another Z-Wave Network - the panel can be placed into Z-Wave inclusion or

exclusion mode to allow it to join/ leave existing Z-Wave networks.

• Soft Reset - a soft reset will reset the Z-Wave controller software. All Z-Wave devices will

remain enrolled.

• Hard Reset - this action will cause your Connect+ Z-Wave module to be restored back

to the default state. Warning: Performing this action results in all Z-Wave devices being

removed from this Z-Wave controller. To add them back, you will first need to exclude

them, and then include them again.

**PLEASE SEE Z-WAVE USER GUIDE FOR ADDITIONAL INFORMATION**

• About - lists information about the panel's installed hardware and software

Unit

GOOD

Over 39

Over 89

Under 200

°F or °C

FAIR

35 to 39

85 to 89

200 to 250

POOR

Under 35

Under 85

Over 250