Alula RE114 Snelstarthandleiding - Pagina 3

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Alula RE114. Alula RE114 12 pagina's. Smoke alarm interlogix compatible

Pagina afdrukken

again, within 4 minutes of the Alarm

re-sounding, will get the Alarm to

compensate for chamber contamination.

This will normally resolve the problem.

If the Alarm re-sounds for a third time,

the Alarm is excessively contaminated

and must be replaced. If it is not

convenient to replace it immediately,

pressing the test button within 4

minutes of it going into alarm (for the

third time) will silence the Alarm for 8

hours – however it will give two short

beeps (second apart) every 10 minutes

to remind the user it has been disabled.

If the contamination clears the Alarm will

return to normal operation.

(Note: this does not reduce the users

fire protection, as a Smoke Alarm in

continuous alarm due to a fault, is

useless and must be silenced – by taking

the Alarm down or as described here.

This procedure has the added benefits

that the user is reminded every 10

minutes by two short beeps that the

Alarm needs to be replaced and that if

the problem clears the Alarm will return

to detecting fire).

1.2.3. Faulty Smoke Chamber

In the unlikely event of the smoke

sensing chamber becoming defective,

the Alarm will give 2 short beeps with 2

yellow LED flashes every 48 seconds. The

Alarm must then be replaced.

If it is not convenient to replace it

immediately, pressing the test button will

silence the beeps and stop the yellow

LED flashing for 12 hours. This can be

repeated as required.

2. Location and Positioning

Introduction

Congratulations on purchasing a Smoke

Alarm. You can easily install these Alarms

throughout the property on escape

routes, on each storey, in corridors and in

closed rooms to give warning of fire.

Heat Alarms can be installed in kitchens

and other areas where Smoke Alarms are

unsuitable.

NATIONAL FIRE PROTECTION

ASSOCIATION REQUIRED PROTECTION

Smoke Detection. Where required by

applicable laws, codes, or standards

for the specified occupancy, approved

single- and multiple-station Smoke

Alarms shall be installed as follows:

(1) In all sleeping rooms and guest rooms

(2) Outside of each separate dwelling

unit sleeping area within 6.4 m (21 ft)

of any door to a sleeping room, the

distance measured along a path of travel

(3) On every level of a dwelling unit,

including basements

(4) On every level of a residential board

and care occupancy (small facility),

including basements and excluding crawl

spaces and unfinished attics

(5) In the living area(s) of a guest suite

(6) In the living area(s) of a residential

board and care occupancy (small facility)

Are More Smoke Alarms Desirable? The

required number of smoke detectors

might not provide reliable early warning

protection for those areas separated

by a door from the areas protected

by the required smoke detectors. For

this reason, it is recommended that

the householder consider the use of

additional smoke detectors for those

areas for increased protection. The

additional areas include the basement,

bedrooms, dining room, furnace room,

utility room, and hallways not protected

by the required smoke detectors.

The installation of smoke detectors in

kitchens, attics (finished or unfinished), or

garages is not normally recommended,

as these locations occasionally

experience conditions that can result in

improper operation.

The equipment should be wired and

installed in accordance with National

Fire Protection Association's Standard

72, Chapter 11 and National Electric

Code, NFPA 70, Chapter 3. (National

Fire Protection Association, Batterymarch

Park, Quincy, MA 02269).

For Canadian installations wiring

methods shall be in accordance with

CSA C22.1, Canadian Electrical Code,

Part I, Safety Standard for Electrical

Installations. Testing and maintenance

procedures shall be in accordance

with CAN/ULC-S552, Standard for

the Maintenance and Testing of

Smoke-Alarms.

IMPORTANT!

Specific requirements for Smoke Alarm

installation vary from state to state

and from region to region. Check with

your local Fire Department for current

requirements in your area.

SMOKE ALARMS

Sufficient smoke must enter your

Smoke Alarm before it will respond.

Your Smoke Alarm needs to be within

6.4 metres (21ft) of the fire to respond

quickly. Smoke Alarms also need to be

in positions where they can be heard

throughout the property, so they can

wake you and your family in time for

everyone to escape. A single Smoke

Alarm will give some protection if it

is properly installed, but most homes

will require two or more (preferably

interconnected) to ensure that a reliable

early warning is given. For recommended

protection you should put individual