ALUZ A1-ZYZY-SQR Handleiding voor installatie-instructies - Pagina 5

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} ALUZ A1-ZYZY-SQR. ALUZ A1-ZYZY-SQR 11 pagina's.

Pagina afdrukken
ZYZY
Square
A1-ZYZY-SQR

MOUNTING GUIDELINES

10"
• For luminaires up to 5'11" in length, use 2 mounting plates.
• Each luminaire ships with holes pre-drilled for attaching the mounting plates.
Each hole is 10" from the end of luminaire to the center of the hole.
10"
• For luminaires 6' - 8' in length, use 3 mounting plates.
• Each luminaire ships with holes pre-drilled for attaching the mounting plates.
Two holes are 10" from the end of fixture to the center of the hole, the third hole is centered on the luminaire.
1
Measure area where luminaire will be installed. Use a laser line to create
a reference line along installation area, ensuring consistent alignment of
mounting plates. Mark location where each mounting plate will be installed
along reference line.
2
Determine number of mounting plates needed for each run. Refer to next
page to ensure correct number of mounting plates are used.
3
Mark location where mounting plates will be installed along laser line.
Note: Holes on mounting plates must be aligned with direction of luminaire.
Laser Line
4
Lay mounting plates and pre-drill using an appropriate drill bit for surface
material and screw size. Each mounting plate must be secured to a solid
surface such as a wall stud or secured to drywall using drywall anchors.
Note: Only install Mounting Plates on flat, even surfaces.
5
Screw Mounting Plates to surface, then snap luminaire into mounting plates.
2' - 5'11"
Mounting Plate
Laser Line aligned with mounting holes
ALUZ
1170 North Red Gum Street, Anaheim, CA 92806
Phone: 800 921 2254 or 714 535 7900 | Fax: 714 535 7902 | [email protected] | aluz.lighting
© ALUZ All rights reserved. ALUZ reserves the right to make changes or withdraw specifi cations without prior notice.
10"
6' - 8'
Centered
ASSEMBLED DIMENSIONS
1.87"
3.59"
Dry or Damp Location
Installation Instructions
9 / 1 / 2021 / Rev 0
Page 5 of 11
Mounting Plates
10"
1.87"
3.59"
Wet Location