ALUZ A8-ZUDA-TAPE Installatiehandleiding - Pagina 8
Blader online of download pdf Installatiehandleiding voor {categorie_naam} ALUZ A8-ZUDA-TAPE. ALUZ A8-ZUDA-TAPE 13 pagina's. Tape
Pagina afdrukken1
Measure area where luminaire will be installed. Use a laser line to
create a reference line along installation area, ensuring consistent
alignment of mounting clips. Mark location where each mounting
clip will be installed along reference line.
2
Use 1 mounting clip every 6", rounded up. Use a minimum of 2
mounting clips per luminaire segment. For vertical applications,
create a stopper at the bottom of the run to prevent sliding.
3
Prepare for mounting by removing backing from double sided tape,
exposing adhesive surface on the underside of mounting clips.
4
Adhere mounting clips to surface.
5
After all mounting clips have been securely installed, install tubes
into clips.
1170 N Red Gum St, Anaheim, CA 92806
aluz.lighting
© ALUZ All Rights Reserved. ALUZ reserves the right to make changes or withdraw specifi cations without prior notice.
A8 Series | Tape
ZUDA Tape
(A8-ZUDA-TAPE)
866.ALUZ.LTG | 714.535.7900
6
Ensure tubes are secured in place.
7
If applicable, connect disconnects between luminaires or solder
connectors using the steps on Application Guidelines.
8
Perform a continuity test before connecting to power source.
Refer to Continuity Test for details.
Page 8 of 12
Mounting Lightstrip
(Wet Location Mounting Clips
for Lightstrip in Square Tube)
Installation Instructions
8 / 11 / 2023 / Rev 1