DLS ACW10 Gebruikershandleiding - Pagina 3
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} DLS ACW10. DLS ACW10 12 pagina's.
Pagina afdrukken
2
1
1. Power Status Led
This bi-color LED glows green when power is
on and no problems are present. lf one of the
protection circuits comes on, it will change to
red.
2. Phase Shift
Use this switch to help compensate for time
alignment problems in the system. Such pro-
blems usually result from having the subwoofer
at a different distance from the listener than the
other speakers in the system.
3.
Auto Power On
The auto power on (ON/OFF) is for high level
(speaker-level) connections. When the switch is
in the "ON" position, the subwoofer auto power
on when there is signal input. If the amplifier
detect no signal input, the amplifier will auto
turn off. lf you prefer to use the remote turn on/
off connection, set the switch in the off position.
Note: Please connect the remote terminal to the
remote output of head unit as
Fig.4. When you turn on/off the head unit a receipt
pulse can be heard from the subwoofer.
4. Low Pass Filter
This control permits you define the frequency
range you want the subwoofer amplifier to
receive. The subwoofer will reproduce all sound
BELOW the frequency you set.
Note: The low pass filter frequency can be higher or
lower than the visual scale.
5. Bass Optimize
The bass optimize controll feature will
enable fine tune of the deepest bass
frequencies.
4
4
3
5
6
9
7
8
6. Input Gain Control
After you have installed your system, turn this
control to minimum.
Turn the head unit on (and the subwoofer will
turn on via the remote connection). Turn the
head unit volume to about 2/3 full level.
Slowly turn up the subwoofer input gain control
until you hear a small amount of distortion.
Then reduce the level until the distortion is
completely gone. Leave the control at this
setting.
7. Remote Level Control Port
Attach the included remote level control to
control the volume level of the subwoofer from
the dashboard.
8. High Level Input
If your head unit does not have RCA out-puts
you can use the speaker outputs for the audio
source for the subwoofer. Use the supplied
cable and wire harness and connect the
outputs properly as shown in the connection
diagram.
9. Low Level Input
Low level inputs are the recommended way to
input the audio signal to the subwoofer if RCA
outputs are present on your head unit or other
signal source (such as a sound processor).
10.
Fuse
11.
Power Input Terminal
10
11