aion Nimbus Handmatig - Pagina 7

Blader online of download pdf Handmatig voor {categorie_naam} aion Nimbus. aion Nimbus 9 pagina's. Dynamic overdrive

ENCLOSURE LAYOUT

Enclosure is shown without jacks. See next page for jack layout and wiring.

Note: The upper pads for the dual-gang gain potentiometer appear to be cut in half. This is intentional!

It's called a plated half-hole or castellated hole, and it's used so that the PCB can lay flat across the pots

instead of angling upward to make room for the dual pot.

Solder it like you would if they were normal pads, but bend the small set of pins forward slightly so they

make contact with the edge of the pads. The solder will flow easily into the half-holes.

125B

NIMBUS DYNAMIC OVERDRIVE