BluCube CXCL Series Gebruikershandleiding & Installatiehandleiding - Pagina 8

Blader online of download pdf Gebruikershandleiding & Installatiehandleiding voor {categorie_naam} BluCube CXCL Series. BluCube CXCL Series 13 pagina's. Circular, flush-mount, in-wall/in-ceiling loudspeakers

Pagina afdrukken
The first step in installing flush-mount loudspeakers in a pre-existing construction is to establish the location of the ceiling joists or
wall studs. You may be able to do this by lifting upstairs floorboards or stud finding tools. If not, you may need to make pilot holes and a
probe but recognise this may entail making good afterwards.
Once a suitable location is identified, you will need to cut out the correct size opening in the surface of the plasterboard using the
supplied cut-out template and a padsaw. You should make a pilot hole first and take care not to cut into pre-existing electrical cables or
pipe-work.
You will need to run speaker cable from the opening back to the amplifier (in the case of the Single-stereo model CXC-650-S and CXCL-
650-S you will need two cables). Ensure you comply with any building codes that may apply in your location.
Fitting the speaker into the cut-out opening
Before inserting the speaker into the opening in the wall/ceiling, attach the speaker cable(s) to the speaker, taking utmost care to
ensure the correct polarity of the speaker wires as this is critical to the correct operation of the speakers.
Insert the speaker housing into the opening and tighten the mounting screws to engage the "swing-dog" fasteners. Be careful to not
over-tighten. The "swing-dog" fasteners will clamp the speaker frame and the mounting surface together.
To insert the speaker grille (CXC range only), start on one edge and slowly work your fingers around the grille edges to ease into the
groove. Make sure all edges are in the groove before applying pressure to insert. It is a snug fit. Do not push on the centre of the grille. If
the grille is not going in, it means that not all edges are in the groove. Ease the grille off and start again.
If the grille needs to be removed, use the supplied finger hook tools to gently ease it out of the housing.
The CXCL and CXRL range have magnetically attached grilles for ease of installation and removal.
Unit 12, Teddington Business Park
Station Road
TEDDINGTON, TW11 9BQ
Phone: 020 8977 8633