DNF Controls SW1X8 Gebruikershandleiding - Pagina 7

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} DNF Controls SW1X8. DNF Controls SW1X8 15 pagina's. Rs422 switcher

INSTALLATION

A. Connect one end of a 9-pin D-type male to male cable into the rear panel

9-pin D-type female connector labeled RS422 Input. Connect the other

end to a VTR Controller.

B. Connect up to 8 RS422 Serial Controlled VTRs using 9-pin D-type male to

male cables into the 9-pin D-type female connectors labeled OUT1 through

OUT8.

C. Connect the Power Supply's 9-pin female D-connector to the rear panel

connector labeled Power. Connect the AC plug to an outlet, 90 VAC to

265 VAC, 50 - 60 Hz. The Power indicator will turn on.

D. When power is applied, OUT1 is active and its indicator light will blink.

Installation is complete.

VI.

To control more than 8 VTRs from a single controller:

A. Follow the instructions in the INSTALLATION section for first 8 VTRs.

B. Connect the RS422 INPUT connector on the second SW1X8 to the 1 X N

EXPANSION PORT connector on the first SW1X8, using a standard 9-pin

RS422 cable, with all 9 pins wired one to one.

C. Remove the top cover of the second SW1X8. Move the

NORMAL/EXPANSION jumper on the main printed circuit board to

"Expansion."

D. Connect VTRs 9 through 16 to the second SW1X8.

E. Connect the third SW1X8 to the EXPANSION PORT connector on the

second SW1X8. Repeat Step d. on the third SW1X8.

SW1X8, RS422 Switcher

Page