DNF Controls SW2X1-RS422 Gebruikershandleiding - Pagina 6

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} DNF Controls SW2X1-RS422. DNF Controls SW2X1-RS422 14 pagina's.

Pagina afdrukken
4.

INSTALLATION SW2X1-RS422

a.
Connect one end of an RS422 cable (9-pin D-type, male to male, 1 to 1)
into the rear panel connector (9-pin D-type) labeled INPUT A. Connect
the other end to an RS422 serial source (controller #1).
b.
Connect a second RS422 serial source (controller #2) in the same
manner to INPUT B.
c.
Connect an RS422 serially controlled VTR, (using an RS422, 9-pin D-
type male to male cable) into the 9-pin female connector labeled
OUTPUT.
d.
Connect the power supply's connector (9-pin female D) into the
housing's POWER connector (male 9-pin D). The PWR LED on front
panel will light. Power supply is +5VDC. 2A.
e.
NOTE: The Power-up state defaults to input A and its status indicator
will light.
Installation is complete.
5.

CONNECTION DIAGRAM SW2X1-RS422

SW2X1 User Manual
6 of 15