Blue Clean AR383 Gebruikershandleiding - Pagina 12

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Blue Clean AR383. Blue Clean AR383 16 pagina's. Power washer
Ook voor Blue Clean AR383: Gebruikershandleiding (16 pagina's)

Pagina afdrukken

Fig. 25

Fig. 27

En - 12

•

Fig. 26

•

• DO NOT store the power washer where it is exposed

Pump Saver is a product that protects and prolongs the life

of the pump. This will keep the internal parts of the pump

lubricated and protected from freezing while being stored in ALL

climates. It also assists with protection from internal corrosion.

The Blue Clean part # is: PW64511 (16oz. bottle ).

Pump Saver Instructions

Follow the previous storage instructions for your power

washer. To prevent staining, protect the surface under the

power washer from any excess fluid. Wear eye protection when

using this product.

1. Turn off your power washer.

2. Disconnect all hoses.

3. Shake the bottle well before connecting to the power

4. Screw the dispensing valve on the bottle of the Pump Saver

5. Turn the valve on the bottle to the open position.

6. Turn the power washer on. Turn the power washer off as

7. Turn the valve on the bottle to the off position and remove

in one of the slots. Lances are pressed into and stored in

the half circle notches (Fig. 22). Make sure to discard any

remaining detergent from the bottle. Flush the bottle and

nozzle head with fresh water to prevent clogging.

Wrap the power cord around the accessory holder using

the extension tabs at the 3:00 & 9:00 position and the

L-shaped power cord holder/tab located at the 6:00

position (Fig. 25).

The pressure hose is stored on the hose reel located

above the accessory holder. With the front of the power

washer facing towards you, insert the un-threaded end of

the power hose into the square hole on the inner reel and

begin turning the handle away from you (Fig. 26). After

you have the reel turned about 1/4 turn, with the fitting

inserted into the square hole, place the hose under the

indentation on the side of the reel to keep it in place while

winding it up (Fig. 27). When finished winding, push the

handle in to lock it in place. Please remember: the hose

reel is only for storing the high pressure hose. The hose

must be completely removed from the hose reel each time

you use the power washer.

to freezing temperatures unless you use Pump Saver.

It is recommended that you use Pump Saver for storing

in freezing temperatures. Freezing will damage the pump

unless Pump Saver is added to the power washer. If not

using or if storing your power washer for more than one

month, run Pump Saver through it. See the section on

Pump Saver for more information.

UmP

aver

washer.

into the water inlet on your power washer.

soon as the Pump Saver fluid begins to exit the water outlet.

the Pump Saver bottle and valve assembly from the power

washer.