Blue Clean AR383L Gebruiksaanwijzing - Pagina 16

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Blue Clean AR383L. Blue Clean AR383L 20 pagina's.

•

This system applies detergent under low pressure. The cleaning power of the detergents

is enhanced when applied with low pressure; and time is allowed to break down the dirt

and grime. The combination of low pressure and chemical action is very effective and can

be better than scrubbing if applied properly. Always spray detergent on a dry surface, do

not pre-soak area. Wetting the surface first dilutes the detergent and reduces its cleaning

ability. Do not allow detergent to dry on surface. On vertical surfaces being cleaned, apply

detergent to lower surfaces and work your way up to prevent detergent from causing

streaks in the dirt and grime. Rinse detergent by pressure washing from bottom up for

same reason.

•

If a stain is particularly tough, it may be necessary to reapply the detergent and use a bristled

brush to scrub the stain. Subsequent power washing after brushing should successfully complete

your cleaning job.

torage

•

Remove lance from the gun and place in the accessory holder. Place the gun in the accessory

holder one the side. Lances are placed into any of the slots in the back of the unit. Make sure

to discard any remaining detergent from the bottle. Flush the bottle and nozzle head with fresh

water to prevent clogging.

•

When your pressure washing session has been completed, turn off the power switch located on

the front of the power washer. Unplug the power cord from the outlet. Turn off the water supply.

Pull the trigger on the spray gun 2-3 times to drain out the excess water and to release any

remaining water pressure. Disconnect the garden hose adapter from the water inlet. Do not allow

the power washer to run with no water flowing through it.

•

Remove detergent tank and clean completely. Residual chemical will stick to the container and

can cause the detergent injector to clock and not function properly.

•

Remove high pressure hose from spray gun and unscrew the other end of the high pressure hose

from the power washer.

•

Wrap the power cord around the L-shaped tabs on the right side of the machine when facing it.

•

The pressure hose is stored on the hose hook located on the back of the handle.

•

DO NOT store the power washer where it is exposed to freezing temperatures unless

you use Pump Saver. It is recommended that you use Pump Saver for storing in freezing

temperatures. Freezing will damage the pump unless Pump Saver is added to the power washer.

If not using or if storing your power washer for more than one month, run Pump Saver through it.

See the section on Pump Saver for more information.