FLAVIA SB100 Gebruikershandleiding - Pagina 6

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} FLAVIA SB100. FLAVIA SB100 11 pagina's. Brewer
Ook voor FLAVIA SB100: Gebruikershandleiding (14 pagina's)

Pagina afdrukken

How to use

Water supply light.

• Water level in the tank is low.

* Please add water.

Beverage settings lights.

• How to choose between the settings:

Espresso type

For a stronger flavor and for ice drinks

• Volume of water extracted: approx. 3oz

Regular coffee/Standard leaf tea

• Volume of water extracted: approx. 7oz

Instant drink

• Volume of water extracted: approx. 6oz

Note: The volume of water extracted is pre-set.

The volume will vary depending on the type of

beverage and filterpack.

Fill the tank with water.

Plug in the appliance and

turn the power switch on.

* At a room temperature of 20°C and a full tank.

Place a cup in the cup stand.

• Recommended cup size to be used with the appliance

is 80mm in diameter and 96mm in height.

Notice

Smaller cups and those with a rounded bottom can cause

splashing when a beverage is dispensed.

• Only use cups suitable for hot drinks.

• Do not use plastic vending cups.

Towards

The setting will automatically

return to

? Make your selection

again.

• Never use any other setting

The light under the

selected setting will

come on.

Notice

an instant beverage filterpack may burst.

Press the start button.

Open the filterpack holder.

Place the filterpack in the

filterpack holder.

Approximately 15 seconds after

closing the filterpack holder, the

'Remove-

filterpack' light will come on.

How to heat water

Water

heated

in the

separator.

*Approx.

3 minutes

Water

heater

*Approx.

minutes

Keep warm mode

How to make a beverage

Select the setting

depending on the

beverage you want.

after 30 seconds.

but the

with instant

beverage filterpacks.

settings ,

On the

and

holder.

Water heating light

• Water is heating.

* Please wait.

Comes on automatically

when water heater starts

operation.

Red light

Time required to make the

first beverage is

approximately 3 minutes.

Another cup can be made

as soon as the green light

comes on.

Green light

If a beverage is made

immediately after adding

water to the tank, the

water may not be

sufficiently hot.

Green light

* Press the start button to open the

filterpack holder, re-select your

preferred beverage setting and close

the filterpack holder.

Press the

start button to

Start

operation

Completing your beverage

When the Remove-filterpack light comes on

Remove cup

Caution

Do not press the start button during brewing.

• For instant beverage, please stir to fully

Notice

dissolve before drinking.

After the beverage is dispensed,

open the filterpack holder and

remove the used filterpack.

• The filterpack will be hot. Take care when

Notice

removing it.

• After the beverage is dispensed, the used filterpack

must be removed. (If the filterpack is not removed,

the beverage making function and hot water

dispensing

function will not operate).

When the filterpack is removed -> Close the filterpack

holder and lower the start button into its original position.

Remove filterpack

light

• This light will come

on when a used

filterpack is left in

the appliance after

making a beverage.

* Please remove the

filterpack.

Light on