ET Water HermitCrab 2 Gebruikershandleiding voor installatie - Pagina 7
Blader online of download pdf Gebruikershandleiding voor installatie voor {categorie_naam} ET Water HermitCrab 2. ET Water HermitCrab 2 12 pagina's.
Pagina afdrukken
Hunter® SRC, I-Core, X-Core
PREPARING YOUR HUNTER CONTROLLER:
1. Set the controller to the "System Off" position.
2. Power off the controller.
ATTACHING THE HERMITCRAB COMMUNICATIONS
CABLE:
1. Connect the three loose wires as follows:
a) Connect the Green or Brown wire to the terminal
labeled "REM" or "R."
b) Connect the Black or White wire to the terminal labeled
"AC2."
c) Connect the Red wire to the terminal labeled "AC1."
Hunter® I-Core
Red
Black or
Green or
wire
white wire
brown wire
Irritrol® MC-E Original + 2011 Versions
PREPARING YOUR MC PLUS B CONTROLLER:
1. Set the controller to the "Rain Off" position.
2. Power off the controller.
ATTACHING THE HERMITCRAB COMMUNICATIONS
CABLE:
1. Connect the HermitCrab communications cable to the
6-pin connector located at the bottom right corner of the
controller's upper panel.
Page 10
Hunter® X-Core
Red
Black or
Green or
wire
white wire
brown wire
HermitCrab communications cable
connects to Irritrol remote connector
Irritrol® Kwik Dial®
PREPARING YOUR IRRITROL RAIN DIAL CONTROLLER:
1. Set the controller to the "OFF or STOP" position.
2. Power off the controller before you connect the Hermit-
Crab.
ATTACHING THE HERMITCRAB COMMUNICATIONS
CABLE:
1. Open up the lower panel of the Kwik Dial.
2. Connect each individual fly wire to each 24 VAC terminal.
The fly wires can be connected to either terminal.
3. Connect the 5 Pin connector into the communication port.
When the HermitCrab is running a station the Irritrol display
will show which station is watering.
Irritrol® MC-E 2011
PREPARING YOUR IRRITROL MC-E 2011
CONTROLLER:
The newer MC-E Irritrol defaults to an "Eicon Remote"
setting. The HermitCrab controller requires the setting to be
changed to "T.R.C Remote". To do
this, follow the steps below:
1. Turn the knob of the Irritrol to the" Options" selection.
2. Press the "next" button to scroll to option #4 which will say
"Retrolink Remote". Press the button labeled "+" to change
the selection to T.R.C
Remote.
3. Turn the Irritrol dial to "Sentinel/Eicon Remote". The
Irritrol will show a brief countdown and then display
"T.R.C Remote Start Receiving".
4. Power off the controller.
ATTACHING THE HERMITCRAB COMMUNICATIONS
CABLE:
1. Connect the HermitCrab communications cable to
the 6-pin connector located at the bottom right corner
of the controller's upper panel.
5 pin cable connected to
Each fly wire in the
the communications port
"24 VAC" terminals
HermitCrab communications cable
connects to Irritrol remote connector
Page 11