DockCraft CR 100 Handmatig - Pagina 8

Blader online of download pdf Handmatig voor {categorie_naam} DockCraft CR 100. DockCraft CR 100 15 pagina's.

Installation - Continued

7 –Similarly to Step #6, Mount the second Dock Mount

Canoe Rack

Position the second dock mount as shown above

Install Snaptogglers and secure mount to dock with screws.

Align Cradle Assembly with the installed Dock Mounts

Engage the pins on the Pivot Laterals in top slot of the Dock Mounts and seat.

Note, rotate the Latch Plates, to prevent the cradle from rotating into the water.

Installation is Complete and you are now ready for the Final Adjustments

Now that the installation is complete, it is now time to SETUP your Kayak Rack to "fit"

your Kayak.

Kayak Storage Rack to Water Level Adjustment:

If the distance to the water from the dock decking is:

10 to 22 inches: insert clevis pin in 2nd hole of the pivot lateral into the top Slot of the mounting bracket.

17 to 29 inches: insert clevis pin in 2nd hole of the pivot lateral into the bottom Slot of the mounting bracket

20 to 31 inches: insert clevis pin in the 4th hole of the pivot lateral into the top Slot of the mounting bracket

25 to 37 inches: insert clevis pin in 4th hole of the pivot lateral into the bottom Slot of the mounting bracket

Adjust if required - up or down - based on your specific watercraft or if your water level changes significantly

throughout the season.

CR 100

SETUP of "The DockSider"

Page 8 of 15

Mark and drill as described in Step 6

Latch Plate