Fleet Complete MGS150 Installatie van bedrading - Pagina 2
Blader online of download pdf Installatie van bedrading voor {categorie_naam} Fleet Complete MGS150. Fleet Complete MGS150 4 pagina's.
Pagina afdrukkenInstallation Guide: MGS150 Hardwire
MGS150 WIRING SCHEMATIC
OVERVIEW OF THE MGS150 LEDS
The MGS150 LED indicator lights have been designed to provide a
simple visual reference regarding the device's current status. The
table describes each status and the respective LED indications.
Green LED
OFF
Power down mode
3 times
No GPRS / No GPS
2 times
No GPRS / Fix GPS
1 time
GPRS OK / No GPS
INSTALLATION
1. Run the ground (black) wire to a suitable
chassis ground by using the crimp ring
terminal.
2. Run the positive (red) wire to the
constant power (+12 volts DC at all
times) and splice an in-line fuse holder to
the end. This is to protect the wire run.
3. Run the ignition switch input wire (white)
to the primary ignition wire in the vehicle.
Locate the appropriate wire under the dash.
When the ignition key is turned to the "On
or Run" position, this will show +12 Volts DC.
Red LED
ON
External power issue
ON
Internal battery issue
1 time
Shutdown / Standby mode
2 times
Idle / Sleep